Casting of Aluminum Alloy Clad Strip Using a Vertical Type Tandem Twin Roll Caster

Ryoji Nakamura; Ryoji Nakamura; Shinji Kumai; Hisaki Watari

doi:10.4028/www.scientific.net/AMR.97-101.1053

Paper Titles

Reclamation of Green Sand Containing Hot-Box Resin Sand and its Application
p.1037

Effect of SDAS on Homogenization of Al-Si-Mg Casting Alloys
p.1041

An Investigation on the Impurities of Aluminum Alloy in Melt Furnace
p.1045

An Investigation on the Overheating of A357 Aluminum Alloy
p.1049

Casting of Aluminum Alloy Clad Strip Using a Vertical Type Tandem Twin Roll Caster
p.1053

Roll Casting of Al-25mass%Si
p.1057

Numerical Simulation and Application of Electromagnetic Stirring in Ansteel
p.1061

Mechanical Properties of Heat Treated 30CrMo Steel Produced by Compact Strip Production
p.1065

Heterogeneous Nucleation for AZ91 with In Situ Synthesis Al₄C₃
p.1069

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 97-101Casting of Aluminum Alloy Clad Strip Using a...

Casting of Aluminum Alloy Clad Strip Using a Vertical Type Tandem Twin Roll Caster

Abstract:

A vertical type tandem twin roll caster which can cast clad strip was devised and assembled. The casting of the clad strip was tried. The three layers clad strip could be cast by a vertical type tandem twin roll caster at only one process. The clad strip was connected directly from AA8079 and AA6022 at roll speed of 30m/min. The diffusion area between the strips was very narrow. The interface between the strips was clear and flat. The strips were bonded firmly.