[1]
F.F. Luz: Comparative Analysis of Fluid Flow in Experiments Using RTM Commercial Applications (MSc. Thesis. Federal University of Rio Grande do Sul, Brazil, 2011). (In Portuguese)
Google Scholar
[2]
R. Stewart: Reinf. Plast., Vol.26 (2002), p.46.
Google Scholar
[3]
G.R. Hiller, J.L. Filla Jr, T.M. Schmidt and S.C. Amico: XVII CBECIMat - Brazilian Congress of Engineering and Material Sciences, 2006, Foz do Iguaçu, Brazil.
Google Scholar
[4]
W.F. Amorim Jr.: Processing the Composite Thick Plate by Resin Transfer Molding Applications (MSc Thesis, Federal University of Rio Janeiro, Rio de Janeiro, Brazil, 2007). (In Portuguese).
DOI: 10.3940/rina.iccas.2011.13
Google Scholar
[5]
G.L.P. Machado, A.C. Garay, P.B. Roese, T. M. Schmidt, J. A. Souza and S. C. Amico: Numerical Simulation of Infiltration in Manufacturing Process for Composite RTM. X CBpol-Brazilian Congress of Polymers, 2009, Foz do Iguaçu, Brazil.
Google Scholar
[6]
A.C. Garay, V. Heck, A.J. Zattera, J.A. Souza and S.C. Amico: J. Reinf. Plast. Comp. vol. 30 (2011), p.1213
Google Scholar
[7]
F. Sánchez, J. A. García, L. Gascón and F. Chinesta: Comput. Meth. Appl. Mech. Eng. Vol.196 (2007), p.2300
Google Scholar
[8]
S. Jiang, L. Yang, S. Alsoliby and G. Zhou: Comp. Sci. Technol., Vol.67 (2007), pp.3316-3322.
Google Scholar
[9]
F.F. Luz, S.C. Amico, A.L. Lima, E.S. Barbosa and A.G.B. Lima: Defect Diffusion Forum, Vol 326-328 (2012).
Google Scholar
[10]
C.D. Rudd, K.N. LAC and C.G.E. Mangin: Liquid Moulding, Structural Reaction Injection Moulding and Related Processing Techniques (Woodhead, Publishing Limited, 1997).
Google Scholar
[11]
F.F. Luz, S.C. Amico, J.A. Souza, E.S. Barbosa and A.G.B. Lima, in: Numerical Analysis of Heat and Mass Transfer in Porous Media, edited by J.M.P.Q. Delgado, Antonio Gilson Barbosa de Lima and Marta Vázquez da Silva, Springer, Heidelberg (2012).
DOI: 10.1007/978-3-642-30532-0_5
Google Scholar
[12]
PAM-RTM – User`s Guide & Tutorials, 2009.
Google Scholar
