Paper Titles

Springback of Laterally Loaded Circular Plates
p.479

Deep Drawability of 5083 Al-Mg Alloy Sheet at Elevated Temperature and its Prediction
p.485

An Inverse Problem of Reinforced Panels Forming
p.491

FE Analysis of Springback in Hat-Bending with Consideration of Initial Anisotropy and the Bauschinger Effect
p.497

Computer-Aided Process Design for Tension Levelling of Clad Sheet Metal
p.503

Direct Evaluation of Sheet Metal Forming Properties under Various Deformation Conditions
p.509

On Alternative Representation of Forming Limits
p.517

Computer Aided Process Planning (CAPP) System for Non-Axisymmetric Deep Drawing Process
p.523

Experimental Study on Large Deformation in Fine-Blanking Process by Implementing Different Stripper Designs: Vee-Ring Type Vs. Plate-Type
p.529

HomeKey Engineering MaterialsKey Engineering Materials Vols. 177-180Computer-Aided Process Design for Tension...

Computer-Aided Process Design for Tension Levelling of Clad Sheet Metal

Article Preview

Abstract:

You might also be interested in these eBooks

Advances in Engineering Plasticity

Info:

Periodical:

Key Engineering Materials (Volumes 177-180)

Pages:

503-508

DOI:

https://doi.org/10.4028/www.scientific.net/KEM.177-180.503

Citation:

Cite this paper

Online since:

April 2000

Authors:

Fusahito Yoshida, M. Urabe

Keywords:

Clad Sheet Metal, Finite Element (FE) Simulation, Optimal Process Design, Tension Levelling

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2000 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation: