Wet Etching Technique to Reduce Pyramidal Hillocks for Anisotropic Silicon Etching in NaOH/IPA Solution

Abstract:

The various methods of silicon wet etching techniques, which utilize ultrasonic agitation to reduce pyramidal hillocks in etched patterns, were evaluated in NaOH+IPA solution. The comparison of the etching methods composed of; 1.) no agitation + sample horizontally orientated, 2.) ultrasonic agitation + sample horizontally orientated, 3.) ultrasonic agitation + sample vertically orientated, and 4.) ultrasonic with rotation agitation + sample vertically orientated. It was found that the percentages of the etched patterns presenting hillocks after etching were 100%, 79.77%, 32.67% and 2.62%, respectively. Ultrasonic coupled with rotation agitation along with the sample vertically orientated is the most powerful etching technique, offering a high yield of smooth etched surface. The difference in etch rate between without agitation and applying ultrasonic agitation was not observed in this experiment, as it was operated in a solution temperature 60-65°C and a 275nm/min etch rate was achieved. The theories that relate to each evaluated method are also discussed.

• Periodical: Key Engineering Materials (Volume 659)
• Pages: 681-685
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.659.681
• Online since: August 2015
• Authors: Chupong Pakpum*
• Keywords: NaOH/IPA Solution, Pyramidal Hillocks, Silicon (100), Ultrasonic Agitation

References

[1] M.H. Kryder, E.C. Gage, T.W. McDaniel, W.A. Challener, R.E. Rottmayer, G. Ju, Y.T. Hsia and M.F. Erden, Heat assisted magnetic recording, Proceeding of the IEEE 96.

DOI: 10.1109/jproc.2008.2004315

[11] (2008) 1810-1835.

[2] A.J. Nijdam, Anisotropic wet chemical etching of silicon pits/peaks/principles/pyramids and particles, Ph.D. thesis, University of Twente, Enschede, the Netherlands (2001) 71-92.

[3] J. Chen, L. Liu, Z. Li, Z. Tan, Q. Jiang, H. Fang, Y. Xu and Y. Liu, Study of anisotropic etching of (100) Si with ultrasonic agitation, Sens. Actuators A 96 (2002) 152-156.

DOI: 10.1016/s0924-4247(01)00786-5

[4] K. Ohwada, Y. Negoro, Y. Konaka and T. Oguchi, Groove depth uniformization in (110) Si anisotropic etching by ultrasonic wave and application to accelerometer fabrication, Micro Electro Mechanical Systems, MEMS'95 Proceedings of the IEEE (1995).

DOI: 10.1109/memsys.1995.472546

[5] C.R. Yang, P.Y. Chen, Y.C. Chiou and R.T. Lee, Effects of mechanical agitation and surfactant additive on silicon anisotropic etching in alkaline KOH solution, Sens. Actuators A 119 (2005) 263-270.

DOI: 10.1016/j.sna.2004.07.015