Injection Behavior of Brushite Bone Cement Prepared with Granulated β-Tricalcium Phosphate

Hyun Woo Kim; Kyung Nahn Park; Kyung Sik Oh

doi:10.4028/www.scientific.net/KEM.758.47

Paper Titles

Fabrication of Mesoporous Silica Thin Film Platforms for Surface Reaction with Surface Plasmon Resonance
p.24

Synthesis and Characterization of a Novel SCPC-CO₃Ap Cement for Pulp Capping Application in Dentistry
p.29

Influence of Silane Treatment of All-Ceramic Surfaces (e-Max) on the Cementation with Tooth Dentine
p.34

Preparation and Characterization of Novel Bioceramic Coatings on Ti6Al4V Substrates for Biomedical Applications
p.39

Injection Behavior of Brushite Bone Cement Prepared with Granulated β-Tricalcium Phosphate
p.47

Hardness Evaluation of Carbonate Apatite Cement Based on Various Ratio of Precursor
p.52

Mechanical Strength Properties of Injectable Carbonate Apatite Cement with Various Concentration of Sodium Carboxymethyl Cellulose
p.56

Fabrication of Carbonate Apatite Cement as Endodontic Sealer
p.61

Apatite Formation Ability of Bioactive Bearing Grade Polyetheretherketone Fabricated by Incorporation of Apatite Nuclei
p.69

HomeKey Engineering MaterialsKey Engineering Materials Vol. 758Injection Behavior of Brushite Bone Cement...

Injection Behavior of Brushite Bone Cement Prepared with Granulated β-Tricalcium Phosphate

Abstract:

The injection behavior of β-tricalcium phosphate (Ca₃(PO₄)₂: β-TCP) based cement was improved through the granulation of β-TCP. Dense β-TCP granules were obtained by heat treatment after spray drying. The fraction of injected paste under loaded mass in the syringe was measured while varying the granular fraction of β-TCP and the heat treatment temperature. The increase in granular fraction and heating treatment temperature reduced the amount of setting agent required to wet the granules. As the surplus setting agent could be used in the powdery β-TCP to reduce the viscosity, improved injectability was achieved. Inappropriate setting by the excessive setting agent was not observed and the cements tested exhibited normal setting behavior by forming a brushite phase.

You might also be interested in these eBooks

View Preview

Info:

Periodical:

Key Engineering Materials (Volume 758)

Pages:

47-51

DOI:

https://doi.org/10.4028/www.scientific.net/KEM.758.47

Citation:

Cite this paper

Online since:

November 2017

Authors:

Hyun Woo Kim, Kyung Nahn Park, Kyung Sik Oh*

Keywords:

Bone Cement, Brushite, Granule, Injection, β-Tricalcium Phosphate

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

Citation:

* - Corresponding Author

References

[1] S.M. Belkoff, J.M. Mathis, L.E. Jasper, Am. J. Neuroradiol. 23 (2002) 1647-51.

Google Scholar

[2] J. Zhang, W. Liu, V. Schnitzler, F. Tancret, J.M. Bouler, Calcium phosphate cements for bone substitution: Chemistry, handling and mechanical properties, Acta Biomaterialia 10 (2014) 1035-49.

DOI: 10.1016/j.actbio.2013.11.001

Google Scholar

[3] M. Boner, Design of ceramic-based cements and putties for bone graft substitution, Eur. Cell. Mater. 20 (2010) 1-12.

Google Scholar

[4] M. Bohner, G. Baroud, Injectability of calcium phosphate pastes, Biomaterials 26 (2005) 1553-63.

DOI: 10.1016/j.biomaterials.2004.05.010

Google Scholar

[5] I.C. Lee, T.J. Chung, K.S. Oh, Preparation of Brushite Bone Cement with a Drug Containing β-Tricalcium Phosphate, Key Engin. Mater. 720 (2017) 143-46.

DOI: 10.4028/www.scientific.net/kem.720.143

Google Scholar

[6] S.A. Lee, T.J. Chung, K.S. Oh, Effect of Storage Conditions on the Setting Properties of Brushite Bone Cement Containing Granular β-Tricalcium Phosphate, J. Kor. Ceram. Soc. 45 (2008) 624-29.

DOI: 10.4191/kcers.2008.45.1.625

Google Scholar