For Libraries For Publication Open Access Downloads About Us Contact Us
Volumes
Key Engineering Materials
Vols. 111-112
Key Engineering Materials
Vols. 108-110
Key Engineering Materials
Vols. 104-107
Key Engineering Materials
Vol. 103
Key Engineering Materials
Vols. 101-102
Key Engineering Materials
Vols. 99-100
Key Engineering Materials
Vols. 97-98
Key Engineering Materials
Vol. 96
Key Engineering Materials
Vols. 94-95
Key Engineering Materials
Vols. 92-93
Key Engineering Materials
Vols. 89-91
Key Engineering Materials
Vol. 88
Key Engineering Materials
Vols. 86-87

Key Engineering Materials Vols. 97-98

DOI:

https://doi.org/10.4028/www.scientific.net/KEM.97-98

ToC:

Table of Contents

Paper Title Page

Structural Investigations of Ultrafine Grained Germanium Produced by Severe Plastic Deformation
Authors: Rinat K. Islamgaliev, František Chmelík, W. Biegel, Ruslan Valiev
79
Plastic Deformation of Fine-Grained Structures Produced from Amorphous Alloys at Elevated Temperatures
Authors: F. Nuxoll, Hartmut Neuhäuser
85
On a Physical Nature of the Yield Stress Anisotropy of Amorphous Alloys Ribbons
Authors: Vladimir Z. Bengus, Václav Ocelík
91
Stress Induced Reordering in Amorphous Metals Analyzed by Relaxation Time and Activation Energy Spectrum Model
Authors: Václav Ocelík, Kornel Csach, A. Kasardová, Jozef Miškuf, Vladimir Z. Bengus, P. Duhaj
97
On Causes of High Local Plasticity of a Bulk Cu50Zr35Ti8Hf5Ni2 Amorphous Alloy during Low Temperature Shear Failure under Compression
Authors: Elena D. Tabachnikova, Vladimir Z. Bengus, V.V. Molokanov, T.N. Mikhailova
103
Superplasticity in Ultrafine-Grained Materials
Authors: Terence G. Langdon
109
Microstructure and Mechanical Properties of Ultrafine-Grained Materials
Authors: B. Baudelet, J. Languillaume, G. Kapelski
125
Phenomenological and Mechanistic Approaches to Optimal Structural Superplasticity
Authors: S.S. Bhattacharya, K.A. Padmanabhan
141
Superplasticity in a Powder Metallurgy Al-Zn-Mg-Cu-Zr Alloy
Authors: P. Málek, J. Erlebach, F.M. Knoop
151
Investigation of the High Temperature Plasticity of Materials by Indentation Measurements
Authors: Quang Chinh Nguyen, P. Tasnádi, András Juhász, Péter Szommer, E. Szép-Kiss, I. Kovács
159

Showing 11 to 20 of 64 Paper Titles

© 2025 Trans Tech Publications Ltd. All rights are reserved, including those for text and data mining, AI training, and similar technologies. For open access content, terms of the Creative Commons licensing CC-BY are applied.
Scientific.Net is a registered trademark of Trans Tech Publications Ltd.