An Abrasive Wear Model of Interpenetrating Composites

Shou Ren Wang; Pei Quan Guo; Hong Yan Wang; Min Wang

doi:10.4028/www.scientific.net/MSF.575-578.1329

Paper Titles

Flashover Condition Analysis on Passenger Carriage Fire by Using Swallowtail Catastrophe Theory
p.1305

Numerical Simulation of Temperature Distribution in Conductive Asphalt Solar Collector due to Pavement Material Parameters
p.1314

Study on Healthful Function of Superheated Water Extractives of Phyllostachys Heterocycla by GC/MS
p.1320

Determination of Chemical Components of Red 1%NaOH Extractives of E. Urograndis Wood by GC-MS
p.1325

An Abrasive Wear Model of Interpenetrating Composites
p.1329

The Effect of Temperature and Content of Conductive Filler on the Conductivity of Conductive Rubber
p.1335

Study of Electroplating Zn-Sn-Ni Alloy
p.1338

The Influence of Surveying Method on Mechanical-Electrical Properties of Smart Mortar
p.1343

Calculation on Temperature Rise of CMP Process: Roughness Effects Considered
p.1348

HomeMaterials Science ForumMaterials Science Forum Vols. 575-578An Abrasive Wear Model of Interpenetrating...

An Abrasive Wear Model of Interpenetrating Composites

Abstract:

Owing to two phases are continuous and penetrated each other, Interpenetrating composites exhibit good abrasive wear properties, can be an attractive candidate for structural and functional materials. Specifically, the abrasive wear model of IPCs is an important topic in the field of tribology. In present work, the model has been proposed according to the mixing rule. Many factors such as special topology structure characteristic of reinforcement, hardness and elastic module are discussed in this model. One kind of Al2O3/Mg composite with different volume content was fabricated and many test data of friction wear were obtained. These data validate the correctness and universality of model.