Study on Drilling Force of Carbide Drill with Different Edge Preparation

Abstract:

The carbide drills with different edge preparation were used for drilling of 40Cr. The influence of drilling speed and amount of feed on drilling forces has been studied by the single factor experiment. The conclusions indicated: when the feed went bigger, the drilling forces of the polished drills were lesser than unpolished drills for un-coating drills; but for coating drills, the drilling forces of the polished drills were greater than unpolished drills. With the increase of cutting speed, drilling forces of un-coating drills mounted up first but went down afterward; and the drilling forces of coating drills increased monotonously.

• Periodical: Materials Science Forum (Volume 723)
• Pages: 481-485
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.723.481
• Online since: June 2012
• Authors: Gang Liu, Zhe Xi Mao
• Keywords: Coating, Drilling Force, Edge Preparation, Polish

References

[1] W.C. Chen, X.D. Liu: J. Mater. Process. Technol. Vol. 99 (2000), p.226

[2] B.L. Zhang: High Efficiency Cutting Technology and Its Application [M]. (Mechanical Industry Press, Beijing 2003)

[3] B.Y. Wang, L.H. Cui: Machinery 04(29) (2002), p.63~65

[4] J.W. Zhong, etc: Mech. Eng. Vol. 10 (2004), p.41

[5] Y.C. Zhang, etc: Machinofacture, 41(8) (2003), pp.37-38

[6] B. Fang, etc: Mech. Sci. Technol. Aerosp. Eng. 24 (12) (2005), p.1452 ~1454

[7] B. Zhang, W. Zhang and Y. Zhao: Tool Eng. 43(2) (2009), pp.36-38