Modelling the Hot Deformation Stress-Strain Curve of a Ni-Based Superalloy

G.E. Kodzhaspirov; A. Borowikow; M. Terentyev

doi:10.4028/www.scientific.net/MSF.762.753

Paper Titles

Atomistic Study of Surfaces and Interfaces of Fe-Cr and Fe-Cr-Al Alloys
p.728

Corrosion Resistance of Welds in 21%Cr Ferritic Stainless Steels – Is it Comparable to Type 304L?
p.734

Effect of Thermal Treatment after Hot Rolling on the Microstructure of Fe-2.4wt.%Si
p.741

Effect of the Si and Al Content in Ferritic Electrical Steels on the Flow Behaviour and Dynamic Softening in Hot Rolling
p.747

Modelling the Hot Deformation Stress-Strain Curve of a Ni-Based Superalloy
p.753

Four Dimensional Description of the Stress-Strain Relationship of Sintered and Swaged Tungsten Powders
p.757

FEM-Based Analysis of Micro-Structure Parameters for Roll Forming on Aluminum Alloy Sheet
p.763

Computational and Experimental Investigation on Thermal Conductivity of SiС Particle Reinforced Al-Matrix Composite Containing Pores
p.769

Forecasting of Hard-Alloyed Cutting Tool Resistance Based on Thermal Diffusivity
p.777

HomeMaterials Science ForumMaterials Science Forum Vol. 762Modelling the Hot Deformation Stress-Strain Curve...

Modelling the Hot Deformation Stress-Strain Curve of a Ni-Based Superalloy

Abstract:

A study on the hot deformation behavior and microstructural changes of nickel based superalloy are presented. Constitutive equation allowing the calculation of peak stress was derived. A study of the effect of the temperature-deformation parameters on the kinetic of austenitic heat-resistant superalloy dynamic recrystallization and on the microstructure evolution was performed as well.