Rheological Properties Analysis of WC-Co Injection Feedstock

Abstract:

In order to produce a defect-free component, the feedstock composition plays as a critical factor. The feedstock needs to meet the following criteria; high solid loading with excellent flowability. The flowability of the feedstock is greatly determined by the rheological response. Therefore, the aim of this paper is to investigate the rheological behaviour of MIM feedstock comprising of WC-Co powder, with a binder system of Palm Stearin (PS) and Polyethylene (PE), by means of a capillary rheometry. The viscosity and shear rate of various feedstocks at powder loading ranging from 59, 61 and 63% were measured at L/D = 10 die. The rheological properties such as flow behaviour index, activation energy and moldability parameter of each feedstock were calculated and from the analysis, it was concluded that they show a good pseudo-plastic behaviour within acceptable ranges in MIM.

• Periodical: Materials Science Forum (Volumes 773-774)
• Pages: 880-886
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.773-774.880
• Online since: November 2013
• Authors: Sri Yulis M. Amin, Norhamidi Muhamad, Khairur Rijal Jamaludin
• Keywords: Metal Injection Molding (MIM), Rheology, WC-Co

References

[1] F. J. Arenas, A. Matos, M. Cabezas, C. Di Rauso & C. Grigorescu, International Journal of Refractory Metals and Hard Materials, Volume 19, Issues 4-6, Pages 235-568 (2001).

DOI: 10.1016/s0263-4368(01)00014-2

[2] R. M German, A. Bose, Injection Molding of Metals and Ceramics, Metal Powder Industries Federation, Princeton, NJ, (1997).

[3] Rhee, B. O., Jung, Y. C. and Lee, J. H. The Rheological Characterization of PIM Feedstocks at Low Shear Rates, Powder Injection Molding Technologies. (1998).

[4] Istikamah, S., Injection moulding of 316L stainless steel powder using palm stearin based binder system, PhD theses, UiTM Malaysia (2010).

[5] Iriany, Kajian sifat reology bahan suapan yang mengandungi stearin sawit untuk proses pengacuanan suntikan logam, PhD theses, (2002).

DOI: 10.11113/jt.v48.217

[6] S.Y. M.Amin., N. Muhamad, & K.R. Jamaludin, 5th Powder Metallurgy Symposium and Exhibition, Kuala Lumpur (2011).

[7] Shimadzu. Shimadzu flowtester CFT-500D: Instruction manual. Kyoto: Shimadzu Corp.

[8] Karatas, C., Kocer, A., Unal, H.I., Saritas, S., Journal of Materials Processing Technology, vol.152, pp.77-83, (2004).

[9] Khakbiz, M., simchi, A., Bagheri, R., Materials Science and Engineering a., vol 407, pp.105-113. (2005).

[10] N.H. Mohamad Nor, N. Muhamad, S. Ahmad, M.H.I Ibrahim, M.H. Ismail, K.R. Jamaludin. Proceeding in Flexible automation and intelligent manufacturing. (2010).