The Press Powder Technological Parameters Optimization in Wall Ceramics Production by the Semi-Dry Pressing Method

Abstract:

The paper presents the fundamental possibility of using ash and slag waste (ASW) of the fuel and energy complex in the production of ceramic bricks using the semi-dry pressing method based on the Buguruslan deposit low-melting aluminosilicate loams. The technological parameters optimization ways (molding moisture, grinding fineness, pressing pressure) in the production of ceramic bricks from low-quality clay raw materials using the experiment mathematical planning method are presented. The separate and joint grinding raw materials mixture rational composition influence on the ceramics technological properties is studied.

• Periodical: Materials Science Forum (Volume 974)
• Pages: 419-423
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.974.419
• Online since: December 2019
• Authors: Victoria A. Gurieva*, A.V. Doroshin
• Keywords: Ceramic Brick, Fusible Aluminosilicate Loam, Grinding Fineness, Mathematical Planning, Mechanical Parameters, Molding Moisture, Physical Parameters, Pressing Pressure, Silicate Block

References

[1] N.K. Skripnikova, I.YU. YUryev, Herald of the TSACU. 2 (2013) 245–249.

[2] N.K. Skripnikova, I.YU. YUryev, Vestnik TSACU. 4 (2011) 127–131.

[3] I.YU. YUryev, N.K. Skripnikova, Material Letters. 3(4) (2013) 268–271.

[4] E.I. Putilin, V.S. Cvetkov, Soyuzdornii, Soyuzdornii, Moscow, (2003).

[5] V.A. Guryeva, A.V. Doroshin, Materials Science Forum. (2019) 1036-1042.

[6] V.A. Guryeva, A.V. Doroshin, Building Materials. 8 (2019) 34–36.

[7] GOST 530-2012 Ceramic brick and stone. General specifications, (2013).