The Method of Assessment of Suitability of the Bearing System Based on Parameters of Technical and Adjustment State

Abstract:

In the operation process, a complex method evaluating technical condition and regulatory status (activities) of the bearing system is used. The method of determination of technical parameters and operating status is known. This is achieved through the interaction of two coupled equations and [2, 3, 7]. It was demonstrated that, on the basis of waveform parameters of technical condition and operating status (respectively), the identification of parametric and momentary damage can be carried out. During the identification process of parametric and momentary damage, it is assumed that damage arises when a parameter threshold value at the time of operation is greater than current permissible value. It is shown how the threshold value of the parameter and its current permissible value, taking into account the number of measurements, are determined.

• Periodical: Solid State Phenomena (Volume 199)
• Pages: 73-78
• DOI: https://doi.org/10.4028/www.scientific.net/SSP.199.73
• Online since: March 2013
• Authors: Paweł Lindstedt, Tomasz Sudakowski
• Keywords: Damage, Diagnostics, Regulation, Reliability, Threshold Value

References

[1] Borowczyk H., Lindstedt P., Manerowski J., Permises for a practical computer – aided parametric method of evaluation of the technical object reliability, Journal of KONES, vol. 16 no 2, Warsaw (2009).

DOI: 10.2478/v10040-008-0119-2

[2] Cempel C., Teoria i inżynieria systemów, ITE – PIB, Radom (2006).

[3] Lindstedt P., The method of complex worthiness assessment of an engineering object in the proces of its use and service, Solid State Phenomena, vol. 144/2009, Trans Tech Publications, Switzerland (2009).

DOI: 10.4028/www.scientific.net/ssp.144.45

[4] Lindstedt P., Borowczyk H., Magier J., Badania możliwości kompleksowego diagnozowania układu łożyskowania na podstawie informacji uzyskanej z metod funkcjonalnej, tribologicznej, wibroakustycznej, Projekt badawczy KBN Nr 5T12D01122, sprawozdanie ITWL Nr 1371/50, Wyd. ITWL, Warszawa (2003).

[5] Lindstedt P., Sudakowski T., Method of prediction of reliability characteristics of a pumping station on the base of diagnostic information, Journal of KONBiN 2(5)2008, ITWL, Warszawa (2008).

DOI: 10.2478/v10040-008-0049-z

[6] Sotskow B. S., Niezawodność elementów i urządzeń automatyki, WNT, Warszawa (1973).

[7] Sudakowski T., Permises of operational method of calculation of reliability of machines on the base of parametric and momentary symptoms of damage, Acta Mechanica et Automatica, vol. 3 no. 4, Bialystok (2009).