Search results

This paper searched a way in order to solve relations between the structures and locking performances for vehicle safety-belt retractor, introduced the emergency locking retractor operating principles, including roll-up mechanism, bearing-strength mechanism, sensitive locking organization.
Established the movement equations include the car-body which accelerates, the carbody lean and the pull out strap which accelerates, according to the equations of motion may the design performance parameters and structure parameters.
Fig. 1 Structure of emergency locking retractor Fig. 2 Structure of cover of left side Roll Up Mechanism.
Fig. 3 Structure of body-feeling and strap-feeling Fig. 4 Equivalent structure of strap-induction Strap-feeling lock mechanism is between the body-feeling mechanism and main frame, as show Fig. 3.Strap-feeling inner notch wheel is fasten with strap-shaft sleeve.
[4] Ruhai Ge: In:Engineering of Automobile Safety(Chemistry Industry.

The phase structure and the morphology were characterized by the X-ray diffraction (XRD) and the scanning electron microscopy (SEM), respectively.
Moreover, the C-rate performance for the composite was also better than that of the pure Li4Ti5O12 resulting from the formation of carbon-based fiber structure.
Recently, Li4Ti5O12 with the spinel structure has been widely researched as the lithium-ion battery anode material because of its high stability [1].
The closed charge-discharge curves for three times are consistent very well, indicating a stable structure for LTO.
Journal of Materials Chemistry. 22(2012) 11257-11260

The structure of the reactive emulsifier (NRS-10) used is shown in Fig.1 (R are unsaturated groups).
Fig.1 The structure of the NRS-10 Characterization.
Particle size of PAs with ketone-hydrazide crosslinking structure which were carried out in compound emulsifier system of SDS/0P-21/MS-1, reactive emulsifier NRS-10, respectively, were investigated.
Synthesis and characterization of a novel fluorine-containing polymer emulsion with core/shell structure.
Fluorine Chemistry, 2006, 127 (2): 282-286

Influence of the Structure of Comb-shaped Polymer on the Adsorption Between the Polymer and SO42- Ions Guorong Duan1,2,a, Xin Wang1,b, Guohong Huang2,c, Ying Gong2,d 1Key Laboratory for Soft Chemistry and Functional Materials of Ministry Education, Nanjing University of Science and Technology, Nanjing, 210094, China 2Ruidi Engineering & Technology Center, Nanjing Hydraulic Research Institute, Nanjing, 210024 China aduangr2003@yahoo.com.cn, bwangx@mail.njust.edu.cn, cghhuang@nhri.cn, dgymm1984@163.com Key words: polycarboxylate; conductivity loss; adsorption; association structure; come-shaped Abstract.
Comb-shaped hyper-branched polymers in aqueous solution would form association super-molecular structure, which could be destroyed by Na2SO4 solution.
Its structure consists of a grafted long-chain macromolecule structure; the main chain has large numbers of carboxylic acid groups, with nonionic polyglycol chains as its branch chains.
Slump-retaining polycarboxylate admixture BT could be obtained using the same methods, but water-reducing agents JS-1, JS-2 and JS-3 as well as slump-loss resisting agents BT-1 and BT-2 were prepared by controlling the acid-ester ratio (the molar ratio of acid to ester) and the length of side chain in the structure.
Long side chain falls into nonionic surfactant, without ionic group in structure and then there is no electrical conductivity.

The XRD pattern confirms that the Fe3O4 nanoparticles belong to cubic structure.
Results and Discussion Structure.
This indicates that the as-synthesized sample is pure Fe3O4 phase with cubic structure.
They are pure Fe3O4 phase with cubic structure.
Ni, Monodisperse Magnetic Nanoparticle Carriers for Targeting Drug, Progress in Chemistry. 21 (2009) 880-889

The structure, morphology and magnetic properties of the products were examined by XRD, TEM, ED, IR and VSM.
The results of the structure and magnetic measurements on NiO nanocrystals were discussed.
Magnetically, NiO is antiferromagnetic with the Néel temperature of 523 K and has the NaCl crystal structure [3].
Then, the crystal structure, morphology and magnetic behavior of NiO at room temperature were examined. 2.
Results and discussion The crystalline structure of NiO calcined at 300 and 500 oC was characterized using an X-ray diffractometer as shown in Fig. 1.

Molecular structure: C3H6+ C5H8O+ Figure 1: The mass spectrum Theoretical calculations This section we use  the B3LYP method, take C5H8O+ stable configuration as the reference configuration, Using the CIS method, the 6-31+g ( D, P ) basis set again to optimize C5H8O+ ground state structure.
All of the molecular structures were calculated by Gaussian03.
Take the C5H8O+ stable structures as a new structure type, with the CIS method at 6-31 + g (d, p) basis we optimized, then calculated the frequency under the same level, the results pointed out that there is no imaginary frequency, we obtained the structure of the C5H8O+ stable structure, energy: E (CIS) = -268.8559 a.u.
Geometric structure Figure 2: C5H8O+ ion ground state stable structures In this section we calculate the theoretical frequency of C5H8O+ excited states.
The basic principles of quantum chemistry and ab initio calculation [M].Beijing: Science press, 1985 [2] K.

, Fabrication and Microstructure of SrBi2Ta2O9 Ceramic Wen WANG 1, a, Haijun NIU 2, b, Hengze XIAN 1 , Jianli YANG1, Hua KE 1 and Yu ZHOU 1 1 School of Material Science and Engineering, Harbin Institute of Technology, Harbin, P R China 2 School of Chemistry Engineering and Materials, Heilongjiang University, Harbin, P R China awangwen@hit.edu.cn, bniuhaijun@hlju.edu.cn Keywords: SrBi2Ta2O9; Ceramic; Microstructure; Dielectric properties.
Recently, bismuth layered structure ferroelectric materials have been widely used for memory applications.
The phase structure of samples was examined by X-ray diffractometer (XRD) with a scanning speed of 10°/min.
Figure 3 indicates that SrBi2+xTa2O9 ceramics sintered at 1200°C for 1h have a single perovskite phase with layered structure.
Bi-layered perovskite structure was obtained.

Gamma-ray Compton Spectroscopy for Determination of Electron Momentum Distributions in Iron Samir Ahmed HAMOUDA1,a 1Department of Physics, University of Benghazi, P.O.Box 9480, Benghazi, Libya adr_s_hamouda@yahoo.ie Keywords: Methods and technologies of Material Characterization, Gamma ray Compton- spectroscopy, Chemistry and Physics of Materials.
It provides a useful test of the electronic structure theories. when monochromatic photons are Compton scattered in a fixed direction, the observed energy spectrum of the scattered photons is Doppler-broadened due to the motion of the target electrons.

X-ray diffraction (XRD) spectra indicated the macroporous materials were anatase structure.
Figure 5(b) also shows a few parts of the membrane are not porous structure but TiO2 nanoparticles, because a small number of smaller microspheres could not be spread on the substrate.
Pore-wall chemistry and photocatalytic activity of mesoporous titania molecular sieve films.
[J]Coordination Chemistry Reviews.248 (2004)1363-1379 [11]H.J.Nam, J.H.Kim.
Two-dimensional nanopatterning by PDMS relief structures of polymeric colloidal crystals.