Search results

Al2O3-13% TiO2 based nanostructured ceramic coatings were prepared on the surface of NiCrAl alloy by Plasma Spraying technology.
Owing to the low melting point and the strong adhesion of TiO2, Compact ceramic compound matrix composite was formed with TiO2 particulate inlaying in the interstice of Al2O3.
Journal of Materials Processing Technology, 2009, 209 (5):2508~2514
Li Properties of Al2O3 based nanostructured ceramic coatings on magnesium alloy surface by thermal spraying Ordnance Material Science and Engineering [J] 2010, 33(4): 39~42
Journal of the European Ceramic Society, 2007, 27 (2~3):1 319~1323.

This type of steel is primarily used in the military, shipbuilding and automobile sectors as it has good concentrations for use in widely available alloys and also meets safety requirements [1].
It was reported that a compound could be categorized as anodic or cathodic based on the shift in the Ecorr value.
Soliman, Influence of 8-hydroxyquinoline addition on the corrosion behavior of commercial Al and Al-HO411 alloys in NaOH aqueous media, Corr.
Rameshkumar, Corrosion Inhibition of mild steel in Acid Media by Alpina galinga Extract, Journal of Applied Chemistry (IOSR-JAC), 4,1 (2013) 61-64
Rao, Starch as an ecofriendly green inhibitor for corrosion control of 6061-Al alloy, J.

In this paper, the idea of B4C/Cu coating FGM (Functionally Graded Material) is proposed with the aim to combine the advantages of low atomic number and low chemical sputtering yield of B4C with high thermal conductivity and high mechanical properties of Cu.
Chemical compound of B4C powder is shown in table 1, and properties of Cu powder is shown in table 2.
Before coating with B4C, the Al-Ni alloy was used to coat on the surface of Cu matrix.
Samm, et al.; Behavior of Carbon and Boron Ccarbon Materials at High Temperature in TEXTOR, Journal of Nuclear Materials; 1992, 196-198:1106-1111 [4] E.Vietzke, V.Philipps, K.Flaskamp; High Temperature Erosion of Boron/Carbon Materials; Journal of Nuclear Materials; 1992, 196-198:1112-1117 [5] H.Bolt, M.Araki; Heat Flux Experiment on First Wall Mock Coated by Plasma Sprayed B4C [6] G.Vieider et al., Plasma facing components in ITER, IAEA-CN531 F-3-12, IAEA Conf.
Zhu, et al., Plasma-surface interaction studies in HL-1 Tokamak, Journal of nuclear materials, 162-164(1988): 448 [10] K.A.Niemer et al., Modeling of runaway electron damage for the design of Tokamak Plasma Facing Components, SANDIA Report, SAND-88-2045(1989) [11] Y.Yamauchi et al., J.

Introduction Phosphate is a compound of phosphorus P.
Initial pH value plays a critical role in the adsorption process because it affects not only the rate of protonation of the compounds, but also the modification of the ionic load of the activated carbon surface.
[4] JORA (Journal officiel de la république algérienne), Décret exécutif du 19 Juin, numéro 34, Algeria, 2011
Achour, Élimination des phosphates par des procedés physico-chimiques, LARHYSS Journal. 4 (2005) 129-140
Shi, Synthesis and characterization of a novel Mg–Al hydrotalcite-loaded kaolin clay and its adsorption properties for phosphate in aqueous solution, Journal of Alloys and Compounds. 637 (2015) 188–196

Rare earth metal Er/Y leads to formation of compounds at the interfaces of ceramics/metal, which in turn purify the interfaces, and enhance the bonding strength of interfaces so that they improve the mechanical properties, but the addition of Y2O3 has not shown the same beneficial effects because oxidized rare earth is hard to distribute homogeneously in the alloy.in additions, Zhu et al. [5] observed that the addition of Ce-Co pre-alloyed powder in Ti(C,N)-based cermets can immensely increase mechanical properties and refine the particles of hard phase.
Vol.1(2003),p.08 (in Chinese) [7]J.X.Zhang,Y.Q.Liu,D.M.Liu,M.L.Zhou,T.Y.Zuo: The Chinese Journal of Nonferrous Metals.
Vol. 14(2004), p.13 (in Chinese) [8]Y.J.Xue,D.Zhu,G.H.Jin,F.Zhao: Chinese Journal of Mechanical Engineering .
Vol.11(1994),p.74 (in Chinese) [12] W.J.Liu,W.H.Xiong,Y.Zhang:The Chinese Journal of Nonferrous Metals.
Vol.16(2006) (in Chinese) [13] Y.Zhang,J.Ma,P.Di,Sh.G.Zhu:The Chinese Journal of Nonferrous Metals.

Journal of Engineering Sci.
Journal of Magnetism Ressonance.
Journal of Alloys and Compounds.
Journal of Mag. and Magnetic Mater.
Journal of Magn. and Magnetic Mater.

Elements of metallurgy and engineering alloys.
The Open Mechanical Engineering Journal. 2008, 2(1), 1-11.
The influence of deep cryogenic treatment on the properties of high-vanadium alloy steel.
Journal of Alloys and Compounds. 2018, 740, 766-773.
Journal of Cleaner Production. 2017, 143(2017), 1060-1068.

Yang, Journal of Advanced Dielectrics, 02, 1230010 (2012)
Yang, Journal of Magnetism and Magnetic Materials, 528, 167824 (2021)
Yamilov, Journal of Magnetism and Magnetic Materials, 588, 171469 (2023)
Nagawade, Journal of Alloys and Compounds, 683, 346–356 (2016)
Rufledt, Journal of Raman Spectroscopy, 51, 1522–1529 (2020)

These membranes aim to ensure the attachment of skin cells to the surface, boost cell reproduction, and support the development of a confluent layer [2].
Figure 5 shows that the compounds detected in AAO film are Al, C and O, with a weight percentage of 93.50%, 3.83 % and 2.67%, respectively.
The primary compound detected using EDX is aluminum, Al compound at 1.5 KeV.
Next, Carbon, C compound at 0.5 KeV as it was contained in electrolyte C2H2O4 and AAO itself corresponds to the existence of oxygen, O compound.
Each of the compounds used in this research will significantly impact the performance of the AAO.

., 2020; Meng & Hu, 2009; Safranski & Griffis, 2017; Wadhawan, 2007; Yahia, 2015) : • Shape memory alloys (SMAs)
European Polymer Journal, 116, 321–329. https://doi.org/10.1016/j.eurpolymj.2019.04.023 [4] Chen, W.
Properties and shape-memory behavior of compounds of a poly(ethylene-co-methacrylic acid) ionomer and zinc stearate.
Journal of Rubber Research, 23(1), 13–22. https://doi.org/10.1007/s42464-019-00031-w [11] Li, G. (2014).
Journal of King Saud University - Science, 29(4), 494–501. https://doi.org/10.1016/j.jksus.2017.09.003 [18] Wu, X.