Search results

The data obtained are in agreement with the proposed hypothesis on the influence of surface active elements to surface tension, graphite wetting with iron and forms of graphite.
The reduction in temperature of crystallisation can not be treated as supercooling which is necessary to realize to obtain nodular graphite.

Besides, traditional data reduction methods for evaluating delamination toughness based on linear elastic fracture mechanics may be not applicable, due to the large bridging zone during the delamination process [7, 8].

This provided a train of thought to design the pipelines reasonably and vibration and noise reduction.
(4) The three dimensional inner flow field of the throttle valve is simulated by means of CFD, which provides details of the reference data for channel optimization and designing this type of throttle valve.

Under dynamic load conditions, the proposed controller was found capable of regulating the speed without the use of an observer resulting in a considerable reduction of size and cost of the system.
[5] Thomson, W.T., and Gilmore, R.J., (2003), Motor Current Signature Analysis to Detect Faults in Induction Motor Drives – Fundamentals, Data Interpretation, and Industrial Case Histories, Proceedings of 32nd Turbomachinery Symposium, Texas, A&M University, USA

This causes a reduction of thermal resistance and in addition transport of salts dissolved in the water and their subsequent crystallisation inside the pore system or on the surface of building materials [2].
Microscopy measurement of aerated NSC Measured data of NSC show different characteristic than the other kind of cement.

By far, most current research of metal rubber materials mainly focused on the mechanical properties, hysteretic model and vibration reduction of energy consumption, and the research of which on fatigue property are much less[1-4].
That is: ; (6) The curves can be drawn between damage factor and cycle index by measured data, as shown in figure 7 and figure 8.

As the output rate of the data is increased, the pulse will become narrower, which magnifies the SSN effect.
Compared to the reduction of the SSN, the increase of transient time is not important, because too large SSN will cause malfunction.

The data were collected with an Ortec Trump MCA in a PC computer.
The behavior of I3 with CDBP or N2SA can be understood as due to an increase in the probability of positron annihilation within the CB in the composite and a corresponding reduction in positronium formation in the rubber that depends on surface area and structure or morphology of the CB particles.

However, the reported data are often not sufficient.
Fig. 2 Microstructures of (a) as-cast AZ31 alloy, (b) 6 hrs annealing at 380 °C, (c) 12 hrs annealing at 380 °C and (d) 18 hrs annealing at 380 °C Table I High temperature compressive strengths and yield strengths at various temperatures annealed for 6 hr, 12 hr and 18 hrs at 380 °C Fig. 3 Microstructures of the extruded bar (a) vertical direction (extrusion direction towards the paper Ä), (b) cross direction (extrusion direction towards right direction) Fig. 4 Tensile stress strain curves of (a) the as-cast and (b)extrude bar at room temperature Fig. 4 shows the stress strain curves of the as-cast and extruded bar with the reduction ratio of 80%.

Research on the effect of filer aid on turbidity reduction and organic matter removal would be conducted
It is necessary to conduct research on the removal effect of activated carbon advanced technology to optimize the data selection.