Search results

By taking advantage of encoding redundancy, the unreliable data can be renewed by other dependable data, and then the system will provide excellent performance of anti-jamming.
A binary data stream is fed into LDPC encoder.
With a reduction of code rate at fixed code length, the performance of LDPC coded system improves while it pays for the descending of throughput.

The system can automatically monitor each water injection layer and regulate water flow in user-defined period without any intervention; it can synchronously regulate flow for each layer; and it also can monitor and adjust flow data by the redisplay of ground host computer.
The present flow values can be recorded by methods of data collection and redisplay in measurement and regulation process and then corresponding curves are drawn.
The water flow does not change suddenly, so to reduce data collection burden and capacity of processor, set sampling period to be 50ms, rated speed of brushless DC motor 3000r/min, and reduction ratio of transmission mechanism 300:1.

The investigation showed that pitting initiated by hot corrosion on the blade surfaces and propagated from the leading edge by fatigue mechanism and finally the blade failed due to the reduction of the cross-sectional area [3].A sudden failure of gas turbine engine three stages turbine blades made of U-500 after only 8000 operating hours investigation was initiated.
Only partial historical operation and repair data were available as shown (Table 1).Due to the seriousness of the found damage, an investigation was launched to identify the failure reasons.
The data was collected from 5o to 85o 2q with a step size of 0.02o, scan step time 1s.
Resulted pattern of the sample was compared with every calculated pattern in a database from the International Center for Diffraction data (ICDD) Powder Diffraction File (PDF) database containing more than 100,000 organic or inorganic substances.

Migration section is the potential of a uniform electric field of diminishing migration of electric voltage is added that of the positive ions in the migration area from high to low, the negative ion migration area is from negative to high voltage negative low pressure, on the move in the area many ring to form even direct ion binding, make ion not obliterated reached the end to spread the ion capture, constant temperature constant airflow work samples stable transfer speed ion, with a temperature sensor, air pressure sensor, humidity sensors, make the results through the computer migration spectral normalized algorithm and the calculation of water vapor interference algorithm reduction in the right transfer rate.
Embedded computer real-time management and monitoring and control system of each device on the ion tube of constant temperature control, gas and flow control, high voltage power supply, the temperature, such as keys in real-time tracking and control; Realize human-machine interface, complete menu graphics display task, according to the operation instructions complete relevant tasks, and shows the result state; Finish on the double channel ion signal sampling, calculation, and sample of the database data analysis comparison, to obtain the result and call the police.
The table below is TNT and heroin mobility data table: Table 1.
TNT and heroin mobility data table muster Molecular formula K0 (cm2V-1s-1) ion form parameter TNT C7H5N3O6 1.542 (1.54 b) [M-H]- air，140oC diamorphine C21H23NO5 1.119 (1.14 a) 1.018 (1.04 a) [M-CH3CO2]+ [MH]+ air，140oC V.

This would reduce the price of the furnace by $60,000 to $ 200,000, depending on the size of the furnace and cause a significant reduction in the capital cost of processing titanium.
Data sheets for the Ti-6-4 are not available and Table 2 shows properties per the BASF Data Sheet [5] from their commercially pure titanium (Cp-Ti) Grade 4.
[5] “Catamold Ti”, Data Sheet D/C A 018 e, Oct 2000, BASF AG, Ludwigshafen, Germany.

The technology offered by the authors can significantly contribute to the implementation of the environmental strategy adopted by Russian Railways in such key issues as resource saving, the environmental burden reduction, the environmental safety of the company's operations improvement, acting as a technological basis for generating additional revenue for the company.
According to data provided on the official website of Russian Railways, to date, the fleet of the company’s rolling stock includes about 20,000 locomotives, most of which use electric propulsion.
The "Aquilon" titrator was used applying computer control system, data collection and processing.
The data obtained (Figure 5) indicate that in the pH range of the solution above 7.0, the existence of soluble trilonate iron complexes is not possible, whereas the rate of cadmium leaching increases significantly with an increase in pH.

However, most of the fatigue data which are used for those strength designs are obtained by uniaxial loading tests, and there is limited data under multiaxial loading [2-3].
Those measured data is used for evaluation of fatigue life and feedback to control the test by using inner pressure and axial load.
The correlation for 316SS also shows the same tendency as that for 430SS under the same loading paths, but the reduction in fatigue life in the Square-shape and the LT-shape is much less; one-digit decrease.

Here, is the crank angle where injection begins, the duration of injection, and the total amount of injected fuel per cycle, which is found by using experimental data under steady-state conditions for the applicable engine-speed and fuel-pump rack position.
The constants x, y, K1, and K2 are found from calibrations against experimental data under steady-state conditions.
Figures 1-3 refer to load changes which are characterized by the following data: the initial load is 15% of the full engine load at the initial speed of 1500 rpm; (b) the full engine load (100%) at 1500 rpm is applied within 0.2 s; and (c) the load type is linear with a total moment of inertia Glot = 1.5kg-m2.
The reduction of heat losses is nowadays the main research activities in the field of internal combustion engines.

However, there is a lack of data on how the individual components of wood react to heat and fire, and how quickly they contribute to the development of fire.
The objective of this research was to supplement these limited data.
Controlled heating of wood can cause reduction in hemicellusoses with no decrease in solidity, which results in higher dimension stability of the wood [7].
However it is only the spruce trunk data that can be compared with the referenced literature.

From Fig. 1a and Table 1, Compared with the blank experiment, the polarization curves of the copper electrode in the acid solution with the guanine shifted obviously to the direction of the current reduction, which implied that the organic compounds could also suppress the cathodic and anodic reactions of corrosion process when the guanine compound were added to solution.
The equivalent circuits used to fit the EIS data of copper were shown in Fig. 2.
The solution resistance Rs, the charge transfer resistance Rct, the constant phase element (CPE), the adsorbed film resistance Rad and the adsorbed film capacitance Cad were fitted and their parameters calculated according to the equivalent circuits model and the data were listed in Table 1.
Equivalent circuit model used to fit the EIS experiment data Table 1 Polarization parameters and impedance parameters for copper in 0.5 M H2SO4 with different concentrations of guanine at 298K C/(mol·L−1) 0 1.0×10−5 3.2×10−5 1.0×10−4 3.2×10−4 1.0×10−3 Polarization parameters Ecorr/mV(vs SCE) -40.9 -49.4 -33.2 -65.6 -40.2 -31.1 Icorr/(μA cm−2) 16.8 5.2 4.5 3.3 2.4 1.3 bc/V −1 1.9 1.9 2.9 5.0 4.1 4.4 ba/V −1 21.7 26.4 33.1 29.2 33.1 35.8 IE(%) --- 69.0 73.2 80.7 86.1 92.2 Impedance parameters Rs(Ωcm2) 1.7 1.1 1.3 1.4 1.1 1.2 Rct/(Ωcm2) 206.7 696.6 803.1 1728.0 2346.0 3498.0 n 0.86 0.80 0.82 0.85 0.84 0.87 Cdl/(μFcm−2) 131.9 173.7 107.7 83.8 50.3 40.2 IE(%) --- 70.3 74.3 88.0 91.2 94.1 The weight loss measurement for monitoring corrosion rate of copper is still widely used because of its simple application and reliability.