Search results

Obviously, the data of this table are for fair materials of the particles, deprived of any defects.
Balance The consumption of heat, mathematical the consumption of gas depending on model temperature and time of sintering Coordinates of lines of a current, Mathematical model fields of local velocities of gas, of gas dynamic lines of equal velocities of gas Thermal capacity of a stream of gas, Mathematical model factor of emission of heat, temperatures of heat exchange of sintered bodies and gas in central points, isotherms of a material and gas Mathematical model Degrees of reduction

These sheet resistance measurement data indicate a higher SPM chemical reaction temperature is not only helpful to improve process throughput but also provides better uniformity and tighter sheet resistance distribution.
The SPM-only processes with higher chemical reaction temperature yield lower and tighter sheet resistance distributions and up to 66% process time reduction.

It is important in reducing the launching cost of spacecrafts, as any reduction in mass and/or power consumption for space instruments or subsystems will result in an exponential savings of the launch cost [1].
The strength tested on nickel is about two times greater than that of published data on electroformed nickel.

The reduction of stiffness depends upon the failure mode in action.
In this paper the former method is used for this method has less data capacity during the damage propagation.

., on the electrochemical energy storage capability of CNTs [2], their electrical properties [3], and on the potentials of filled nanotubes in high density magnetic data storage [4].
The two magnetization curves in Figure 5 illustrate the change in magnetization at T = 5 K with reduction of the average lateral core size from 60 nm (Fig. 5a) to 15 nm (Fig. 5b), a decreasing saturation magnetization from about 9.6 emu/g to 1.2 emu/g, and the increase of the coercivity from 470 Oe to 2550 Oe.

Additionally, the attenuation of electromagnetic wave and the non-homogeneity of sub-surface materials give rise to a reduction in quality of the radar image.
At this time, it is better to calculate for data over threshold value of intensity.

The distinctive physical and chemical properties of WO3 make it suitable for technological applications as transparent electrochromic devices, selective catalysts for oxidation and reduction reactions or transparent conducting electrodes.
The electrical conductivity was determined using the van der Pauw method and from data shown in figure 5 .The increase of conductivity values is closely related with to the Mo concentration in the starting solution.

Introduction Age related bone fractures caused by the reduction of mechanical performance of CBT (Cancellous Bone Tissue) reflect tremendous sociological and economic implications on aging population.
Since there is no data using fresh trabeculae of human lumbar vertebra, the measure permeability coefficient could not compare directly to macroscopic level.

The experimental data indicated clearly that the higher the content of co-solvent, the higher is the solubility of M30 at low temperature, and the amount of co-solvent required increases linearly with the temperature reduction.

In order to obtain similar specimens as nature corrosion in a short period, and get enormous amounts of experimental data, the method of electrochemical accelerate corrosion has been used widely [2].
The steel rebar lose electronic under the current, the valency of the rebar increased, and oxidation reaction occured; While the copper sheet get electronic, the valency of the copper decreased, reduction reaction happened.