Search results

In addition, the average Al/N ratio is 1.12:1.
During the CS, Al particle was initially nitrided from the surface through a direct nitridation reaction (Al(s)+1/2N2(g)→AlN(s)), leading to a rapid increase of temperature.
In this case, the un-nitrided Al particle would melt and formed a liquid Al core.
Due to the low solubility of nitrogen in Al core at this temperature, the direct nitridation and supersaturation of Al core with nitrogen led to the multiple nucleation of AlN embryos on the surface of the Al core [11].
El–Geassy: J.

El Haram, Giza P.O. 136 Giza, code 12211, Egypt Email: fawzyhameed@yahoo.com Keywords: ZnOnanorods, MEH-PPV, thin film, spray pyrolysis, solar cell Abstract.
Krunks et al.,[8], presented Spray pyrolysis as a new simple route for the synthesis of ZnO nanorods.
Jie Liu et al [14] reported that transitions at 850 and 965 cm-1have dipoles normal to the phenyl-vinyl plane.
Al-Hilli, Z.

The chemical composition of blank is shown in table 1： Table 1 The chemical composition of blank C Si Mn Cr N P S Ti Al B 0,20 – 0,25 0,20 – 0,35 1,10 – 1,30 0,15 – 0,25 0,009 0,025 0,005 0,020 – 0,050 0,020 – 0,060 0,002 – 0,005 Hot Forming Process for Experiment. 1.
Zone A Zone B side wall Zone 3 Zone 1 1 Zone 2 Fig. 8 The hot formed part: Front pillar gusset-R Table 2 Tensile properties TS (MPa) EL(%) As delivered 530 10 zone A 1474 7 zone B 1510 6 Vickers Hardness Distribution.
Trans Tech Publications Ltd., Palermo, Italy, [4] Gu Zheng-wei, Shan Zhong-de, Xu Hong, et al.
[5] MA Ning, HU Ping, SHEN Guo-zhe, et al.

Ranganatha et al. showed that by heat treatment of the coatings and also adding TiO2 nanoparticles, the electrochemical characteristics of the coatings could be improved [1].
Pan Tao et al. [4] showed that adding some nanoparticles like ZnSO3, Zn3(PO4)2 and ZnSiO3 instead of Zn leads to increase in corrosion protection of these coatings.
Rabizadeh et al. [7], which possesses a relatively same percentage of P.
Abo El Enin: Surf.

The TN was determined using a CHNOS Elemental Analyzer (Vario EL，German), while TP was analyzed using an inductively coupled plasma atomic absorption spectrometry (ICP/AES).
Cambardella et al. [5] grouped the coefficient of variance (CV) as low (CV<0.1), moderate (CV between 0.1 and 1) and high (CV>1).
Additionally, Yao et al. [6] presented that both soil moisture and soil salinity were high in this study area, and their variations were moderate.
Additionally, Mao et al. [10] reported that soil parent material, soil type and soil erosion could greatly influence the scale effect of nitrogen distribution.

Introduction Zinc selenide (ZnSe) is an n-type semiconducting material with wide band gap (2.7 eV) and being in great demand in application of ectroluminescent (EL) displays and solar cells.
Vol.16 (2008), p. 235 [3] C Liangyan, Z Daoli, Z Guangmei, et al.
Vol.120 (2010), p. 456 [4] D A Johnston, M H Carletto, K T R Reddy, et al.
Vol. 403-404 (2002), p.102 [5] B Asenjo, A M Chaparro, M T Gutiérrez, et al.

According to the research of Wallace et al. (2002) and Trochanis et al. (1988) [6-7], 11 D (D is diameter of drilled shaft) is adequate for the outside diameter of the entire mesh.
W.et al. ( 2002).
Rep.No.EL-5915, Electric Power Research Institute, Palo AltoCalif.1988

The common test techniques for the defects of the silicon panels are Photoluminescence(PL), Electroluminescence (EL), Dark lock-in thermography and Machine vision imaging(DLIT), etc.
PANG, et al, The Application of Electrolum inescence Imaging to Detection The Hidden Defects in Silicon Solar Cells.
Boyeaux, et al.
Trupke, et al.

Tab.1 Tensile properties of DD32 and SRR99 single crystal superalloy E 0.2YS UTS EL RA Alloy Temperature /℃ GPa MPa % DD32 20 202.5 876.5 1097.8 17 19 SRR99 20 122.3 1047 1065.2 10.4 14.5 DD32 900 156.1 746 906 25.5 23 SRR99 900 82.8 874.9 989.1 25 35.3 From the microstructure observation on the longitudinal section of DD32 samples after stress rupture tested at 1000°C/280MPa, it can be seen that fully developed γ' raft structure is aligned mainly normal to the stress axis, and some γ' rafts are parallel to the stress axis (Fig.2a).
Frazier et al., High Temperature Materials for Power Engineering 1990, Part Ⅱ, ed.
Bachelet et al.
Dofdrecht, The Netherlands: Kluwer Academic Pubilishers, (1990) 1281-1300 [4] Jinjiang YU et al., The effect of Re on the microstructure of a single crystal superalloy DD32, J.

Park, et al.
[7] N Linh-Trung, A Belouchrani, Abed-Meraimet K, et al.
[8] A Aissa-El-Bey, N Linh-Trung, Abed-Meraimet K, et al.
[10]S Arberet, A Ozerov, R Gribonval, et al.