Search results

Therefore, the tools will displays all necessary data for SCC mix design and the constituent materials for the required volume.
The reduction in the flow Sample BA0 BA10 BA15 BA20 BA25 BA30 Slump flow dia.

MQL is expected to provide some favorable effects, mainly through reduction in cutting temperature.
In general, the data indicates that as the cutting length increase, the flank wear also increases in non-linear behavior.

The XPS data were collected using monochromatic Al Kα radiation at 1486.92 eV, and 20 eV constant analyzer pass energy.
The oxidation/reduction process (Ni2+/Ni3+) registered at ~0.5V in un-implanted AISI 304L is not observed in the coimplanted steel.

Introduction The response of damaged multilayered structures is a topic of main importance because defects, due to manufacturing processes or operating conditions, may lead to an abrupt reduction of the load carrying capacity of the component [1].
Table 2 and 3 contain the data of the materials and of the stacking sequences used for the numerical examples; all plates have a total thickness h=1 [mm].

When analyzing misorientation between crystallites by the OIM system, data points in the middle of grains were used for measurement.
For Pb alloy, the applied cold rolling reduction was 30% which was larger than that for other materials listed in Table 1.

The plates were forged at 900oC with a reduction strain of R=50% (one pass, strain rate: 50%/s) using 400 ton hot press machine (dies temperature: 350oC) after austenitizing at 900oC for 1200s, followed by quenching in oil.
Sugimoto: unpublised data

These results were attributed to the reduction of the intermolecular CTC between alternating electron-donor (diamine) and electronacceptor (dianhydride) moieties.
The thermal behavior data of all the CBDA based fluorinated PIs are given in Table 4.

In order to meet the demands of circular economy, energy saving and emission reduction, sustainable development, developing a new technology to reduce SO2 emission, suitable sintering conditions and economic running, is urgent need of iron and steel industry [9].
The curves, plotted according to the data in Table 2, were shown in Figure 1.

Its steps are: Previously, noise of the obtained data caused during the measurement needs to be reduced.
Further research will focus on the ranging factors and error reduction.

Data from the same year indicate that 85.5% of the population permanently occupies houses connected to sewerage and the length of the sewerage network is 48,491 km [1].
Already during saturation on the saturation line (Fig. 1 and Fig. 2), the sleeve can be stretched, resulting in a reduction in thickness.