Search results

Based on these data, the samples were sintered at a temperature of 1410 ° C, with a holding time of 2 hours and a heating rate of 3 ° C / min.
Despite the fact that the mechanical properties of the obtained ceramics, at the moment, are not significantly inferior to the properties of the samples obtained by traditional ceramic technologies, the proposed technology benefits from a reduction in cost, production time and energy costs, as well as due to the possibility of manufacturing ceramics with complex topology.

After loading 5 wt% of zeolite, the reduction of tensile strength was observed due to the poor interaction between PBAT matrix and the agglomeration of zeolite.
Data, 61 (2016) 1547–1554.

Generally, the blast major data provided in the manual is based on a bare spherical TNT explosive and can be extended to apply to other types of explosive materials.
Consequently, the degree of failure observed in the fiber-reinforced geopolymer concrete showed reduction in tensile failure as depicted in Fig. 3.

The traditional use of dragon fruit tree had been discovered to promote healing wounds and cut, improves appetite, eye sight, weight reduction and improves memory [3].
The data recorded for three replicates of each concentration of BAP and Kinetin were plotted in graph form and comparison was made.

The heating rates were selected based on the data from the literature and preliminary studies and were Vheat=15°C/c; Vcool=7,5°C/c respectively.
The final, grain radius after thermal cycling, similarly to the discounting operation, can be calculated by the formula (1) (1) where – relative reduction in grain radius as a result of a single processing cycle; n – number of thermal exposure cycles.

By computer network the enterprise constructs intelligent dynamic system on shopping -- warehouse - production material and carries out material data keeping update so as to buyers determine reasonable purchase batch and purchase time for avoiding the backlog or shortage of inventory loss.
The enterprise should use the production equipments of energy conservation and emission reduction, and enforce lean manufacturing to avoid the largest extent wastes.

When the temperature is higher than 650℃, the adsorbate product has been basically completed removal, and the yield of chloride tends to be stable, however yield of activated carbon decreased gradually, it is for reduction of dry weight.
The experimental results on the optimized conditions were iodine adsorption value of 1003.59mg / g and the yield of regeneration activated carbon of 70.00%, the error of experimental values and predicted values was less than 2%. 3.6 Mechanical strength of activated carbon Table 2 Mechanical strength of activated carbon Spent AC Fresh AC Regeneration AC H (%) 92.74 92.11 91.55 H1(%) 93.71 93.79 92.80 The H was used to express mechanical strength of activated carbon, when error between H and H1 was less than 2%,the data valid.

From many points of view, development and advancement of gamma titanium aluminides technologies is regarded as a key factor of competitive advantage for achieving the targets of improvement of the engine efficiency, of reduction of carbon dioxide emissions and for opening the design space for new generation gas turbine engines.
Load history and points of DIC data acquisition for a fatigue tension experiment.

Therefore, type k thermocouples were used with the radio data logger (measuring amplifier) Cobra SMARTsense, PHYWE Systems, Germany.
The friction-spinning process with driven tool leads to a maximum temperature of Tmax = 510 °C with a wall thickness reduction from s0 = 5 mm initial thickness to s = 2.7 mm flange thickness.

The reduction of the impurities form the coating and crucible might also be necessary, but this increases the cost of consumables.
Some data from the growth using nucleation agent coating are added for comparison.