Search results

The data obtained from the analysis of particle size distribution indicates a size distribution for granules in the range from 0.08 to 0.3mm for the HA-Zn powder.
The narrowing of diffraction line can be explained both by the increase of the crystallites size (table 1) and to a reduction of the residual stress level due to the heat treatment.

The quality data of three kinds of water were shown in Table 1.
Off hard pretreatment removes most of the calcium and magnesium ions, and inorganic fouling on RO membrane surface is relative reduction, so the range of flux attenuation is lesser than direct ultrafiltration.

It followed the evolution of the temperatures during 20 minutes of phone conversation, the data acquisitions were realized at every 5 minutes of conversation.
The future researches will be focused on the modalities of the reduction of the effects of EMR fields produced by mobile telephony under the human factor.

Boron-oxygen defects are the responsible defects for the light-induced degradation and in order to suppress the light-induced degradation, the reduction of oxygen concentration by means of MCz technique, the use of n-type silicon wafers and gallium doping instead of boron were suggested in an international joint research for light-induced degradation in 1999 [9].
According to the lifetimes data of cast silicon wafers, p-diffusion and hydrogen passivation were effective to reduce the n.d.c to a limit which might prevent the solar cell from degradation.

Introduction Following the trend for the reduction of greenhouse gas emissions and fuel consumption, automotive manufacturers are continually looking at ways to reduce vehicle weight.
[3] Technical Data Sheet: Anticorodal-121 AA 6016 (Alcan Rolled Products Automotive, Switzerland, 2002) [4] M.

That corresponds with tabulated data (see, for example, [16]).
The two-position regulation is the reason behind frequent temperature reductions between the 4th and the 5th section.

Many researchers agree that the strength of material enhanced by increasing Si ratio [7, 8], but after getting optimum compressive strength additional silica in the matrix causes reduction in strength.
Table 1: XRF Data Analysis of Fly Ash.

Table1 Driving style frequency statistics Driving style Calm style Aggressive style Average acceleration / Acceleration mean square deviation S/S 27 0 S/M 52 0 S/B 33 0 M/S 57 0 M/M 36 8 M/B 10 31 B/S 0 41 B/M 0 50 B/B 0 32 Table2 Driving style probability statistics Driving style Calm style Aggressive style Average acceleration / Acceleration mean square deviation S/S 100％ 0％ S/M 100％ 0％ S/B 100％ 0％ M/S 100％ 0％ M/M 82％ 18％ M/B 24％ 76％ B/S 0％ 100％ B/M 0％ 100％ B/B 0％ 100％ Based on the statistics of the experimental data, the highest occurrence probability group is chosen to represent the rules of the fuzzy logic inference.
Fig13 is the SOC trend of the SOC economic control strategies, which depicts that the SOC has a distinct reduction during the whole driving circle.

(1) In order to measure data more intuitively and easily, we can define the ratio of depth to diameter K, to show the taper simply : (2) So, (3) In order to avoid accidental error caused by instability of the processing equipment, 5 holes samples were evaluated in each process and average is taken out of them.
When the laser processes the bottom of the workpiece, because of the overflow of the gasified material, the laser energy will rapidly decay, leading to the reduction of the processing efficiency.

This was truly contributed to improve the pn hetero-junction quality due to remarkable reduction of thickness on the n-type CdS window, which significantly enhanced the short-circuit current density (Jsc).
Accuracy of quantitative results refers to whether a technique needs calibration by reference samples or reference measurements (standard), which may be difficult in some cases (i.e., since the fitting of the model to the experimental data requires a large number of parameters), or whether a technique is entirely standard-less.