Search results

This result confirms the experimental data of [4,5], but it is not enough to confirm a percolation phenomena of the transition.
The main advantage of the model is reduction of a dimensionality of the system and making an ability to estimate its thermodynamic values without cumbersome calculations.

The reduction in the intensity of bands during ripening with respect to the original intensity was expressed as percentage of hydrolysis.
Because the difference of the initial material which effected the data.

Moreever, new products such as liquid crystal display (LCD) and plasma display panel (PDP) significantly cut down the production scale of CRTs in the very near future.A dramatic reduction of the closed-loop recycling is anticipated.
The aim of this article is then to provide data to aid the investigation of promising re-use applications to waste CRTs.

Beam-end load and vertical displacement are automatically collected by the MTS data acquisition system, and drawn hysteretic loop.
However, after the specimen yields, with the load level increasing, the hysteretic curve gradually turns into spindle-shaped, showing a good anti-seismic energy dissipation capacity. 2) Before the specimen is destructed, in each sub-cycle of the same level loading, load-bearing capacity has not been reduced, which indicates that joint strength degrades to a small extent under cyclic loading. 3) When the load level increases, the joint’s load-unload curve slope decrease continuously, but the reduction amplitude of the loading curve slope are larger than the unloading ones, which indicates that the joint's load stiffness degradation are more obvious than those of unloading.

Therefore, three-dimensional elastic beam element Beam4 is used in longitudinal-connected plate and U-bar. 2.2 Construction of mesh generation finite element model Finite element mesh generation is critical for the finite element numerical simulation analysis, which directly influences the accuracy of calculation and analysis result of successive data.
is the reduction coefficient of concrete.=0.35.

There are many sources of tracking error, including structural deformation of tracking mechanism, mechanical clearance of reduction gears, and set-up errors.
The strain data were then recorded and saved in a notebook computer.

It is also leading to the reduction of energy. 4.0 Conclusion The characterization of flashlamp driver circuit has successfully been carried out.
All the data from the measurement and calculation is used to explain the details characteristic about the flashlamp driver.

The only pollutant from hydrogen combustion is NOx, so the reduction of NOx emission is much more important than that of combustion of conventional fuels.
Li et al. [2] has proved the accuracy of the kinetic mechanism for NOx emission; compared with experiment data, the simulation error for flame temperature and NO concentration are within 30K and 2ppm respectively, which are within the experiment uncertainty.

These foil gauges had some distinct advantages, most notably a reduction in size and production costs.
In all these cases, the use of strain gauges and data logging could have provided vital information and, in the latter two cases, could well have prevented the accidents.

Table 2: Components in solid waste Cost per Kg Percent Material 1200 46.0 Paper 1400 19.0 Paperboard 7500 5.0 Pet 3050 3.0 Plastic bags 3700 6.0 Plastics 2700 4.0 Metal 250 7.5 Glass 1000 3.0 Plastic containers 16000 0.5 Metallic containers 0 6.0 Other wastes Figure 1: Comparison of different solid waste components By chemical analysis of different components the following data was obtained which are listed in table 3.
In the first 4 months period of year 2012, 5.7 percent reduction in solid waste production was recorded.