Search results

Yang: submitted to International Journal of Machine Tools and Manufacture (2002)
Lee: submitted to the International Journal of Advanced Manufacturing Technology (2002)
Poo: submitted to International Journal of Machine Tools and Manufacture (2003)
Ying: submitted to International Journal of Machine Tools and Manufacture (2007)
Andrew: submitted to Measurement Science and Technology (2011)

A better understanding of matter at then a no scale has led to a number of advances in materials science having novel optical and electronic properties.
The formations of high strength materials have wide scale applications.
Ghodsi, Growth, characterization and studying of sol-gel derived CdS nanoscrystalline thin films incorporated in polyethylene glycol: Effects of post-heat treatment, Solar Energy Materials & Solar Cells 105 (2012) 249-262
Grun, nanocrstals of CdS dispersed in sol-gel silica glass: optical properties, journal of crystal growth 144 (1994) 141-149
Bhatnagar, Structural and optical investigations on CdS thin films grown by chemical bath technique, Materials Chemistry and Physics 68 (2001) 22-30

Modified materials can improve the hardness by 51.22 to natural rubber.
The acid treatment results in a greater total pore volume for the partially amorphized materials than for the totally amorphized mineral.
Intercalation Intercalation reaction of inorganic layered materials has been well-known as a method for preparing inorganic organic multilayer nanocomposites, which have drawn increasing attention in recent years.
Journal of Thermal Analysis and Calorimetry 2005; 81: 457–462
Journal of Colloid and Interface Science 2006; 294:362–370

The exhaust manifold’s material properties are shown in Table 3.
Applied Mechanics and Materials (2011) 800-803
Liu, Numerical simulation of thermal loads for engine exhaust manifold, Journal of Huazhong University of Science and Technology 12 (2006) 98-100
Vibration isolation of exhaust pipe under vehicle chassis, Intonation Journal of Vehicle Design 15 (1994) 131-142
Hormaza, Fracture of an exhaust manifold, Materials Science and Technology Conferenceand Exhibition (2012) 1479-1485.

Introduction The detection of explosives and explosives related illicit materials is an important area for preventing terrorist activities and for putting a check on their deleterious effects on health.
Sol-gel materials are used very often in sensors for its advantages of low-cost, easy-processing, and variety of material composition.
The sense material of MEH-PPV was dip coated onto the surface of POF.
The prepared sensing material was dip-coated on the section.
Barat: Semiconductor Science and Technolog, Vol.20 (2005), p. 266 [3] D.

To study the T4 temper, the material was allowed to age at room temperature (25 o C) for at least 120 hours [2,5].
[2] Möller, H., Govender, G. and Stumpf, W.E. (2007) Natural and artificial aging response of semisolid metal processed Al-Si-Mg alloy A356, International Journal of Cast Metals Research 20, 340-346
[3] ASM Specialty Handbook: Aluminium and Aluminium Alloys (1993) Materials Park, Ohio, ASM International, 718-720
[5] Möller, H., Govender, G. and Stumpf, W.E. (2008) Investigation of the T4 and T6 heat treatment cycles of semi-solid processed aluminium alloy A356, Open Materials Science Journal 2, 11-18.
Acknowledgements Financial support from the Department of Science and Technology (DST) is gratefully acknowledged.

The La0.67Ca0.33MnO3 powder was synthesized by heating the starting materials in air at 1373K for 15h, 5h and 15h with intermediate grindings.
Journal of Physics: Condensed Matter, 1997, 9(39): 8171
Colossal magnetoresistant materials: the key role of phase separation[J].
Colossal-magnetoresistance materials: manganites and conventional ferromagnetic semiconductors[J].
Nanoscale phase separation in colossal magnetoresistance materials: lessons for the cuprates[J].

Progress in Materials Science 2012;57:268-435 [2] S.Y.
Journal of University of Science and Technology Beijing 1999;21(2):131-134 [4] L.M.Lu,H.Soda,A.Mclean.
Microstructure and mechanical properties of Fe-Cr-C eutectic composites.Materials Science and Engineering:A 2003;347:214-222 [5] J.H.Kang,P.E.J.Rivear.
Computational Materials Science 2013,67:364-372 [6] P.Gembalova,J.Boruta,E.Grycz,etc.
Thermo-calc&Dictra,computional tools for materials science.Calphad 2002;26(2):273-312 [8] W.C.Robert,H.Peter.

Experimental Materials.N-isopropylacrylamide(98) was from shanghai things race chemical technology Co., LTD.
Author introduction: GAO Hong(1969-),Doctor degree, associate professor, native place: Jinzhou Liaoning Province, Research Interests: new functional materials.
Progress in Polymer Science. 2007, 32(11):1275-1343 [4] Okano T.
Molecular design of temperature-responsive polymers as intelligent materials.
Investigation of swellable poly (N-isopropylacrylamid -e) based hydrogels for drug delivery.Materials Science and Engineering: C.2011, 31 (5): 1084-1090 [17] Bao-Lin Guo, Qing-Yu Gao .Preparation and properties of a pH/temperature -responsive carboxymethyl chitosan/poly(N-isopropylacrylamide) semi-IPN hydrogel for oral delivery of drugs .Carbohydrate Research.2007,342(16): 2416-2422 [18] P.E.

Simulation Study Hastelloy-X material was selected in the simulation work.
Table 3 shows the time-dependent material properties of Hastelloy-X.
The material of the insert is WC + TiAlN coating and the insert has a rake angle of 00 and a relief angle of 70.
Abotula, A.Shukla, and R.Chona, “Dynamic Constitutive Behavior of Hastelloy X under Thermo-Mechanical Loads”, Journal of Materials Science 46(14) (2011), 4971–79, doi:10.1007/s10853-011-5414-y
[9] M.Aghaie-Khafri, and N.Golarzi, “Forming Behavior and Workability of Hastelloy X Superalloy during Hot Deformation”, Materials Science and Engineering: A 486 (1–2), (2008), 641–47, doi:10.1016/j.msea.2007.11.059