Search results

Some of the works gives overall review on the investigated MMSF systems that are most important, for example Santa-Maria et al. and Fergusson et al. investigated the microstructure and quasi-static compressive mechanical properties of Al-A206/Al2O3 MMSFs.
Besides Al the material contained 12.83 wt% Si and about 0.2 wt% other elements (Fe, Cu, Mn, Mg, Zn).
In the GC hollow spheres the Al-Si-O ratio followed the composition of the ceramic wall.
Abou El-khair, M.
Rohatgi, Al–Al2O3 syntactic foams – Part I: Effect of matrix strength and hollow sphere size on the quasi-static properties of Al-A206/Al2O3 syntactic foams, Mater Sci Eng A. 582 (2013) 415-422

The translation modes of Al-OH are observed at 771, 735, 670, 554 and 460 cm-1.
The absorption band at 425 cm-1 is the translation of Mg-O-Al [22].
Maca, et al., for HIPed transparent MgAl2O4 ceramics [25].
Yajima, Synthesis of Mg–Al spinel powder via precipitation using ammonium bicarbonate as the precipitant, J.
Nuernberg, E.L.

Shamarka et al [1] studied the thermal image prediction by using an infrared thermometer.
Alam et al [2] utilized a gradient-based registration algorithm in MATLAB to estimate the shifts of moving frames.
He et al [3] discussed three kinds of methods to call MATLAB in the Visual C.
El Shamarka, M.

Lee et al. used MOCVD for catalyst-free growth of ZnO nanowires [8].
The determination of the Powder XRD Pattern Indexing was carried out by Smith [9] and Boutif and Louer with the software DICVOL91 [10] and Werner and al. with the software TREOR90P [11].
Hirschwald et al, “Zinc Oxide”, Current Topics in Materials Science, Vol. 7(3):143-482 (1981)
El-Shaer, A.

In 1981 Shohata et al. developed a ZnO-based multilayer chip varistor by applying the same manufacturing process as a multilayer ceramic chip capacitor.A multilayer chip ZnO varistor is a device designed for low breakdown voltage and high surge absorption.
[3] DUAN hui,WANG Houzhi,ZHAO Lei,el at.
[5] Pagnoux C, Chartier T, Granja M F, et. al.
[6] Nahass P, Rhine W E, Pober R L, et al.

The magnitude of the external load is first determined by a static analysis so that the initial SIF of the crack is consistent with the experiments performed by Gaylon et al [11].
Wachspress, E.L., A rational finite element basis.1975, New York: Academic Press
Meyer, M., et al., Generalised barycentric coordinates on irregular polygons.
Gaylon, S.E., et al.

H2 H2 Condensate Heater El.
Wasserscheid et al., Dehydrogenation of Dodecahydro-Nethylcarbazole on Pt(111), 2013, 10.1002/cssc.201300263J
Wasserscheid et al., Energy Environ.
Wasserscheid at al., Evaluation of Industrially Applied Heat-Transfer Fluids as LOHC Systems, ChemSusChem, 2013

References [1] E.L.
Băran, Al.
Băran, Al.
[11] Al.

Referring to Chong et al. [7] and discussed in previous section, the leading edge of the guide vanes were located at 28.6° of 12cm radius.
From these results, when compared to results from Normayati et al. [11] in Table 2, it proves that with the installation of baffle, flow uniformity distortion can be reduced up to 63%.
The best produced pressure recovery of Cp = 0.526 was recorded when the system operated at maximum Rein = 1.775E+05, compared to Cp = 0.239 recorded by Normayati et al. [12] at the same Rein with 54.6% deviation of improvement.
References [1] El-Askary, W.A., and Nasr, M., 2009, “Performance of a Bend Diffuser System: Experimental and Numerical Studies,” Journal of Computer & Fluids, 38, pp. 160-170

The seismic wave was a EL-Centro wave with a peak acceleration of 0.15g.
(In Chinese) [4] Adalier K, Elgamal A, Meneses J, et al.
(In Chinese) [8] M H Zhao, J B Sun, Y J Zhang, et al.
[10] Jiang M M, et al.