Search results

Experimental In this paper, different lateral MOSFETs were fabricated on 4◦-off-axis n-type (0001) 4H-SiC epitaxial layers (1 × 1016 cm-3), with a p-type Al-implanted body region (NA ~ 1017cm-3).
El, IEEE Trans.

Emery et al [10] suggested a method for establishing a general calibration approach for orthotropic composites and showed for the type of composite used the response was a function of the resin rich surface layer and that largely the orthotropic material response could be neglected.
[11] El-Hajjar R, Haj-Ali R.

Table 1 Chemical compositions of waste samples (mass%) Elements V Fe Si Ti Si Na Content 1.19 38.03 5.52 6.58 5.52 4.86 Elements Cr Mn Ca Mg Al O Content 3.08 3.74 1.59 0.75 0.55 33.785 X-ray diffraction pattern of raw materials is shown in Fig. 2.
El-Nadi, N.S.

These materials known as functionally graded composites (FGC) are introduced by Oyekoya et al., who used them to analyze the buckling and vibration of plates made out of them.
El-Zafrany, "Buckling and vibration analysis of functionally graded composite structures using the finite element method," Composite Structures, vol. 89, pp. 134-142, 2009

[10] Enz C, EL-Hoiydi A, Decotignie J-D, et al.

Xit is a controlled variable, including the actual log-value of per capita GDP(ly) and its quadratic term (ly2), the percentage of secondary industry’s added value in GDP(wg2), equivalent log-value of personnel throughout the research and experiment(lrd), foreign trade dependence(ti), effective levy rates(el) which shows how hard the province is trying and urbanization rate(cir). 2.
In other words, with the percentage of secondary industry remain the same, or the structure of three industries remain unchanged, the industrial restructuring within manufacturing industry can bring significant effect on emission deduction, which corresponds with Vukina et al.(1999) who believed that when energy-intensive industries start to transform into knowledge-intensive and service industries, the pollution will go down accordingly

Silin, E.L.
Silin  et al, Mechanochemical Synthesis of High Alloyed Powder Alloys of the Fe–Cr–Ni–Mn–N System, Russian Journal of Non-Ferrous Metals, Vol. 54 № 6 (2013) 508-512

Wang et al., have shown an overpotential of 230 mV for cobalt telluride as electrocatalysts for HER [2].
Walter, E.L.

Chemical Composition (%) Mg Al Zn Mn Fe Cu Si Ni Ca AZ31B Balance 2.98 0.99 0.5 0.0026 0.0005 0.019 0.0005 0.001 Experimental Procedure and Specimens The Hopkinson bar or Kolsk’s bar [12] is used for both compressive and tensile high strain rate testing of the alloy.
Gullett, Haithem El Kadiri, W.

Se Hyun Ahn et al. reported that using of ultra short pulses with tens of nanosecond duration is a good way to localize dissolution area [8].
El-Taweel, A.H.