Search results

As a result, a new reactor with showerhead gas delivery and radiation heating system is designed. 1.
Suntola in the 1970s[1].
Fig. 1 a) the axonometric graph of chamber; b) the bottom graph of chamber 2.2 ANSYS simulations Fig. 3 The thickness of aluminum oxide (6.52+ 0.11nm) Fig. 2 a) pressure distribution; b) temperature distribution (two heating pipes with the range of 379~474℃); c) temperature distribution (four heating pipes with the range of 463~479℃) A conjugate heat transfer analysis is conducted by ANSYS CFX.
The thickness map of sample A is shown in Fig. 3 (1.7% uniformity) and all data is shown in Table 1.
References [1] T.

Experimental Procedures The composition of High speed steel was listed in Table 1.
The composition of the sample is qualified by referring Table 1.
Fig.1 A and B show the microstructures of the brim and middle position of the centrifugal cast HSS respectively.
References [1] M.
A Vol. 479 (2008) p. 253

A waste button battery could pollute 600 tons water, equaling to the amount of drinking water in one's whole life [1].
Results and Discussion Fig.3-1 FT-IR spectra of EG Table1 Assignment of absorption peak of EG in FT-IR spectra Peak Location(cm-1) Chemical Structure and Motions 3468 N-H Sretching Vibrations 1639 N-H bending Vibrations, C=C Stretching Vibrations 1562 C=C Sretching Vibrations 1414 C=C Sretching Vibrations 1384 C=C Sretching Vibrations Fig.3-1 and Table1 show that expandable graphite has a specific band maximum in the 3600~3200cm-1 region.This region is dominated by stretching vibrations of O-H or -NH,-NH2 groups.
And the infrared spectrum indicates that expandable graphite has another four absorption peaks respectively at 1639cm-1,1562cm-1,1414cm-1 and 1384cm-1 ,which means there may be aromatic compounds with C=C in them. 3.1.
References [1] R.X.
Exfoliation process and elaboration of new carbonaceous materials, Fuel 1998, 77: 479–485

The left of this region is the fluid inlet, and the speed is maintained uniform as U=0.1, as shown in Fig. 1.
The condition design is shown in Table 1.
The results have shown that: (1) When Re≤50, flow is laminar, the recirculation zone length increases with Re increases.
Journal of the science and technology. 1 (2012) 59-63
Europhys Lett. 6 (1992) 479-484

The detail specifications of eight kinds of specific CMG wheels were listed in Table 1.
As shown in Fig.1, the specific CMG wheels were shaped in cylindrical, which was easily and economically to prepare.
Table 1 Specifications of specific CMG wheels (vol.)
Fig.1.
Zhou: Materials Science and Engineering Vol.479 (2008), P.373 [8] Libo Zhou，Shinat，Qiu Zh J: Precision Engineering Vol.33(2009), P.499 [9] Arivazhagan Rajendran, Yasufumi Takahashi, Michihisa Koyama: Applied Surface Science Vol.244 (2005), P.34 [10] Zhou L, Eda H, Shimizu J, Kamiya S, Iwase H, Kimura S: CIRP Annals Vol.55 (2006), P.313

Results and discussion Fig. 1 shows the typical SEM images of the deposits prepared by electrochemical deposition at the current density of 10mA/cm2 and pH value of about 2 on the ITO glass.
Fig. 1 SEM images of deposits synthesized by electrochemical deposition on ITO glass at current density of 10mA/cm2 and pH value of about 2.
Fig. 4 SEM images of deposits synthesized by electrochemical deposition on ITO glass at pH value of about 2 and current density of 1(a), 5 (b), 15 (c), and 20mA/cm2 (d).
References [1] A.P.
Xiao: Material Science Forum Vol. 475-479 (2005), p. 3579 [11] B.P.

Figure 3 shows the XPS results for InP for a H2SO4/H2O2 solution of pH 1.
Figure 1: Etching kinetics measured by ICP-MS for GaAs and InP in acidic H2O2 solution.
References [1] N.J.
[2] J.A. del Alamo, Nature 479 (7373) (2011), p. 317
Technol, 3 (1) (2014), p.

The optimal classification hyper plane, refers not only to all the training samples for accurate classification, and can make the distance classification hyper plane point nearest to the plane of the largest distance, As shown in Figure 1： H1 H H2 Fig. 1 The Optimal Hyperplane In Fig.1, H is classification line of the two classes of samples the inerrant separate. , are lines through two kinds of samples from the classification with recent samples and parallel to the linear classification respectively.
References [1] Pan Quan,Yang Feng,Ye Liang et al.
Journal of Harbin Institute of Technology. 2006,13(1):113-117
Machine Learning and Applications (ICMLA), 2010 Ninth International Conference on: 479 – 484
Machine Learning Journal 2009, 77(1):27-59.

Two atomic structures with different metal/insulator interfaces are shown in Fig.1.
Table 1.
The results were shown in Table 1.
References [1] T.
Forum Vol. 475-479 (2005), pp. 2255.

Start timing after the five test-tubes were laid until detonate, (see Fig.1).
Fig. 1 Deflagration Results and Discussion The stabilizer contents (Ak II and Res) of the samples were measured by GC.
All measured values by GC and methyl-violet test are listed in table 1-3.
411 413 413 1 1.07 1.60 401 403 404 404 406 3 1.10 1.60 394 395 397 399 401 5 0.92 1.57 386 387 387 390 391 7 0.83 1.60 380 382 384 384 389 9 0.71 1.60 370 373 373 378 379 11 0.60 1.59 357 357 359 361 364 13 0.40 1.56 337 337 338 340 342 Scattering Field Of Methyl-Violet Burst Times From table 1-3, it can be found that the repeatability of the tb is good for same ta.
References [1] Jiang Jin-yong, Lu Gui-e, Su Zhen-zhong, et al.