Search results

Besides that, nanoparticles also differ compared to their parent materials which highly enhanced in their physio-chemical, mechanical, electrical, thermal, and hydrodynamic properties [3].
The laws that inhibit the macro and micro-scale material behavior are significantly diverse than the nano-scale behavior, as the sizes of nanos are approximally close to the atomic scale compared to both macros and micros [15][16][17].
Oil & Gas Journal, (2009)
Journal of Petroleum Technology. 58 (2006) 24-26
American Journal of Applied Sciences, 9 (2012)

Considering the ceiling and sound-absorbing material in the superstructure, it can be controlled within the "City railway traffic induced vibration in buildings and the two radiation noise limit and measurement method of standards" (hereinafter referred to as the" standard").
Study on vibration of Futian underground hub in Guangzhou-Shenzhen-Hongkong high-speed rail[C]. 2nd International Conference on Civil Engineering, Architecture and Building Materials.Yantai, China [2] S.
Journal of Sound and Vibration,1979,66(3)：363-370
(Science Press, China 2010)(In Chinese)
(China Railway Publishing House ,China 2008) (In Chinese) [7] Wanming Zhai :Vehicle-track coupling dynamics ( Third Edition )(Science Press, China 2007)(In Chinese) [8] Guanghua Yang.

Materials and Methods Instruments and reagents.
Material.
References [1] Jinxin Peng, Huijun chen，“Water quality eutrophication and prevention”, Beijing, China Environmental Science Press, 1988
[2] Cunxian Yan，“The comprehensive utilization of fly ash”，Shanghai Environmental Science, Vol.15, 30-33, 1996
[3] BAYAT B，“Comparative study of adsorption properties of Turkish fly ashes”，Journal of Hazardous Materials, Vol.95, 275-289, 2002

It can be accomplished by a traditional actuator in which action is based on the lifted mass acceleration measurement, but active materials here are more promising.
Inertial load control by active materials: 1- loading mass, 2- 4 - pulleys, 3 – damper, 5 – handle, 6 – plate, 7 – pin A complicated law of loading, when the loading mass is not too large, may be accomplished by the arrangement shown in Fig. 3, b.
The possibilities of stabilization and control of arm muscle loading when lifting weight guided by pulleys have been analyzed and relevant design solutions exploiting rheological fluid material application have been proposed.
Science and Practice of Strength Training. –2 nd ed.
Journal of Neurophysiology. 2000, vol. 83 pp. 2030-2039.

Laser methods for coloring and marking silver products are very promising due to high accuracy, high processing speed, and implementation without additional consumables, such as, for example, coloring materials.
Materials and Methods As a material for the research, round silver plates (0.925: 92.5% silver, 7.5% copper) were selected with a diameter of 9 mm and a thickness of 0.9 mm, since it is the most common type of silver for various applications.
Acknowledgments The study is funded by a grant Russian Science Foundation (project № 19-79-10208).
Van Duyne, Nanosphere lithography: effect of substrate on the localized surface plasmon resonance spectrum of silver nanoparticles, The Journal of Physical Chemistry B 105 (2001) 2343-2350
Pou, Production of silver nanoparticles by laser ablation in open air, Applied Surface Science 336 (2015) 108-111

Preparation and Characterization of Cd1-xZnxS Thin Films with Chemical Bath Deposition Limei ZHOU1,a , Yunlong LI1,b and Yuejie DONG2,c 1School of Material Science and Engineering, Dalian Jiaotong University, China 2Sunoasis Co.
Introduction Recently, Ⅱ-Ⅵ binary and ternary compounds, especially CdS, ZnS and Cd1-xZnxS, have been widely used as a band gap window material in photoconductive devices [1,2] and heterojunction thin films solar cells[3].
Journal of Alloys and Compounds 509(2011) 9428 [2] Yi Yang, Jinman Huang, Bai Yang, Shiyong Liu, Jiacong Shen.
Applied Surface Science 115 (1997) 386 [6] Ran Zhai, ShuBo Wang, HaiYan Xu, Hao WangT, Hui Yan.
Materials Letters 59 (2005) 1497 [7] J.M.

Tour et al: Science 278 (1997) 252
Tour: Science 28
Japanese journal of applied physics Vol. 47, No 6, 2008, pp. 4969-4974
[17] Aissa Boudjella.Applied Mechanicas and materials.
Applied Mechanicas and materials.

Information pertinent to the production versus outsourcing problem apparently includes the cost of raw materials, the company’s hourly rate, the product’ s sale price, total machine time dedicated to the product, work time at the bottleneck, product flow through the different resources etc.
The cost of raw materials incorporated in product is denoted by .
Journal of Human Systems Management.
Chemical Engineering Science.
Chemical Engineering Science.

Adsorption of Cr(VI) from aqueous solution by two kinds of pillared bentonites Zhen Wang1,2,a,* , Zesheng Cheng1,b, Yu Liu1,c, Nana Bo1,d, Shuping Li2,e 1Key Laboratory of Pulp & Paper Science and Technology, Shandong, Jinan, China 2 key laboratory of cleaner production and industrial waste recycling and resourcization in university of Shandong (Shandong polytechnic university) awangzhenyft@126.com, bsdczs19870211@163.com, cleoliuyu@163.com * Corresponding author: Wang Zhen, E-mail addresses: wangzhenyft@126.com, Tel:15864791007 Keywords: modified bentonite, smectite, Cr(VI), effluent, adsorption Abstract.
It is a suspected carcinogenic and toxic material which has a great harm to the human health.
Materials and methods Materials.
Applied Clay Science, 2006. 31(3-4): p. 194–206
Chemical Engineering Journal, 2012. 187: p. 79-88

Besides the length and frequency, the material constants and parameters of FEM are as same as ones of calculation above.
Acknowledgement This work was supported by National Natural Science Foundation of China with Grant No. 50475158.
Xu: Key Engineering Materials, Vols.259-260 (2004), pp.10-13
Youssef: Journal of Material Processing Technology, Vol.55 (1955), pp.254-260
Lin: Principle and Design of Ultrasonic Horn (Science and Technology Press, Beijing 1987), pp.190-210.