Search results

Acknowledgment The authors wish to thank the Ministry of Science, Technology and Innovation (MOSTI), Ministry of Education (MOE), and Universiti Teknologi Malaysia (Research Vote Nos. 4S045, 03H59, and 4F291) for the financial aid.
You-Ping, Surge breakdown properties of soil, in Electrical Insulating Materials, Proceedings of 1998 International Symposium on. 1 (1998) 429-432
Rajab, Investigations of earthing systems under steady-state and transients with FEM and experimental work, International Journal of Electrical Power and Energy Systems. 44 (2013) 758-763

Precipitate Behavior and Microstructure Characterization of An Al-Zn-Mg-Cu Alloy Prepared by Spray Forming Process Baohong Zhu1,a , Baiqing Xiong1,b , Yongan Zhang1,c, Udo Fritsching2 , Jishan Zhang3 , Feng Wang1 , Zhihui Li1 and Hongwei Liu1 1 State Key Laboratory of Fabrication and Processing for Nonferrous Metals, General Research Institute of Nonferrous Metals (GRINM), Beijing, P.R.China 2 Chemical Engineering Department, University Bremen, Bremen, Germany 3 State Key Laboratory for Advanced Metals and Materials, University of Science and Technology Beijing, Beijing, P.R.China a zhubh@grinm.com, bemail: xiongbq@grinm.com, cemail: zhangyongan@grinm.com Keywords:Al-Zn-Mg-Cu alloy, rapid solidification, spray forming process, artificial ageing.
[2] P.Lengsfeld, J.A.Juarez-Islas, W.A.Cassada, et al., International Journal of rapid solidification, No.8 (1995), p.237

Materials and methods Algae species and culture conditions.
Acknowledgements This work was financially supported by National Natural Science Foundation of China (41171389), research project of Liaoning province office of education (2009A174) and Dr start-up fund research of Liaoning province (NO. 20081076) References [1] Z.
Backhaus:Journal of Environmental Quality Vol.29(2000), p. 1063 [11] T.

Finite element modeling Some reasonable assumptions are used in the finite element model established by large structural analysis program ANSYS, to maximum limit quality variation and the change of rigidity in the finite element model[2] (before and after reinforcement, the difference volume of concrete demanded in superstructure of the bridge is 2.3%, the quality difference in FEA model is 6% , and quality difference of bridge deck system is only 0.4%), which can more objectively modeling the geometry of structure, material properties, and the authenticity of the boundary connecting conditions. reasonable assumptions are as follows: (1).The upper structure is dispersed into lattice beam system contains a series of longitudinal and transverse spatial three-dimensional beam (BEAM4)
Without considering the material nonlinearity in calculation, (4).
Acknowledgement: The research reported was financially supported by National Natural Science Foundation of China (No. 51278208) and Technology Program A of the Education Department of Fujian Province (No.
International Journal for Numerical and Analytical Methods in Geomechanics, v 36, n 4, p 517-532, March 2012

Materials and Methods Bacterium and medium.
Journal of Dairy Science.

The image obtained from Co/TiO2 precursor depicts several larger agglomerations of particles (Fig. 1A) and show that this material has a less dense and homogeneous morphology.
Conclusions A new carbon paste electrode modified with Co/TiO2 nanocomposite material, prepared by the sol–gel method, was constructed and optimized for the determination of antibiotic CF.
Pandey, Voltammetric Sensor Based on Nano TiO2 Powder Modified Glassy Carbon Electrode for Determination of Dopamine, Open Chemical and Biomedical Methods Journal 3 (2010) 115-22
Ho, Synthesis and characterization of Fe-doped TiO2 photocatalyst by the sol–gel method, Advances in Natural Sciences: Nanoscience and Nanotechnology. 1 (2010) 015008

Therefore, in order to play the effects of water environmental audit more effectively, some projects as an independent performance audit projects should have a clear idea of the basic performance audit, and should be not only satisfied with the discovery of some illegal financial revenue and expenditure audit problems, but also take these issues as a basic materials for performance audits and to analyze the reasons, and then put forward opinions and suggestions to promote water pollution prevention and environmental protection .
In the curriculum Financial institutions, it can be considered to increase environmental science, environmental accounting, environmental economics, and environmental auditing courses, and it can make the knowledge structure more reasonable to improve the overall quality of students.
References [1] Lin Wang, ShengNa Hu: Modern Economic Information, 2013 [2] Information onhttp://www.china.com.cn/policy/txt/2011-08/02/content_23119604.htm [3] ShuCui Yu: Green Finance and Accounting, 2012, Vol.4, pp.22-24 [4] Margaret Murphy , Emily Conant: Environmental audits: The battle among EPA, congress, and the state legislatures, edited by Environmental Claims Journal, 1995, Vol.8 (2) [5] Lewis, Linda, L.

Acknowledgements This work is financially supported by the National Natural Science Foundation of China (No.51378436) and the technical development program of the China Railway Corporation (No.2010G018-C-1-3).
Journal of Modern Transportation. 2014, 22(1): pp:1-11
Applied Mechanics and Materials, 2014, Vols: 488-489: pp: 390-393

On the basis of knowledge library, non-geometry information such as structure types and materials are derived from reasoning model based on Rule Based Reasoning(RBR), geometry information is got from further reasoning.
Acknowledgment This work was financially supported by the National Natural Science Foundation (50575148)， Engineering University of Armed Police Force basic research fund (WJY201307) Corresponding Author Yu Yang, miaoyude@163.com, 15229203836 References [1] Yan Chuliang,Yang Fangfei,Zhang Shuming: TRANSACTIONS OF THE CHINESE SOCIETY OF AGRICULTURAL MACHINERY.Ei.
Forum Vol. 35 (2004), p. 211 [2] TAI Ligang, ZHONG Tingxiu: Journal of Donghua University.Ei.

Acknowledgments This work is supported by National Natural Science Foundation of China (No. 50968003) and Technical Research Project of Guangxi (NO.0995001).
Journal of Harbin Engineering University,Vol. 32(2011), p.895-905.In Chinese
[3] Zongping CHen, Yisheng Su, Hongpu Peng.New Building Materials, 2009,p.19-23.