A Study and Comparison of Calculating Grüneisen Parameter Using Different Methods

Ting Zhang; Meng Qiang Wu; Ming He; Jie Xiong; Song Chen

doi:10.4028/www.scientific.net/AMR.146-147.1102

Paper Titles

Microstructures and Mechanical Properties of the Mg-xGd-Er (x=5, 7, 9 and 11wt%) Alloys
p.1080

Using CFRP to Repair the Steel Pipe with Fatigue Cracks
p.1086

Dynamic Visco-Elastic Properties of Polycarbonate (PC) under Static and Dynamic Load
p.1090

Microstructure Evolution in the Atomized Droplets of Mg-9wt%Al Alloy
p.1094

A Study and Comparison of Calculating Grüneisen Parameter Using Different Methods
p.1102

Improvement of Porosity of Strip Using a Scraper on the Casting by a Vertical Type High Speed Roll Caster
p.1108

The Effect of Composition on High-Energy Laser Beam Combustion Synthesis of Fe-Al Alloys
p.1114

The Study of Nitrogen Absorption with Slagging in High Nitrogen Steels Smelted by High Pressure and Bottom-Blowing Nitrogen
p.1120

Characterization of Composite Coatings Produced by Plasma Electrolytic Oxidation Plus Cathodic Electrophoretic Deposition on Magnesium Alloy
p.1126

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 146-147A Study and Comparison of Calculating Grüneisen...

A Study and Comparison of Calculating Grüneisen Parameter Using Different Methods

Abstract:

Some attempts for getting Grüneisen parameter are discussed. After comparing, the Grüneisen parameter got from Grüneisen EOS and Vinet EOS is consistent with the experimental data. However, we are not sure which method can describe the behavior of the Grüneisen parameter good under high pressures, because of the lack of directly measured data for Grüneisen parameter under high pressures. So, the technology for directly measuring Grüneisen parameter should be developed for clarifying this problem by experiments.