Stability Analysis for the Milling of Thin-Walled Plates

Abstract:

In order to restrain the regenerative chatter and improve the processing efficiency of thin-walled parts, stability analysis for the milling of thin-walled parts should be the critical element in the whole process of analysis for thin-walled parts. This paper mainly introduces the stability analysis for the milling of thin-walled plates. The two-dimensional stability lobes of milling of plate plotted, the effect of different modal parameters on the stability of milling of plate is investigated. It is shown that single mode will reduce the range of stability zone of main mode if the stability lobes of single mode are intersectant with that of main mode and the range of stability zone will be larger and the stability lobes will be regular on condition that the mode is symmetrical.

• Periodical: Applied Mechanics and Materials (Volumes 105-107)
• Pages: 117-120
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.105-107.117
• Online since: September 2011
• Authors: Kai Wu, Ai Jun Jiang, Kai Yang
• Keywords: Damping Ratio, Milling, Mode Superposition, Stability, Thin-Walled Plate

References

[1] Y. Altintas, E. Budak: Annals of the CIRP, Vol. 44(1995) No. 1, p.357.

[2] G. X. Li, Q. Liu: Agricultural Machinery Journal, Vol. 39 (2008) No. 10, p.194 (In Chinese).

[3] A.J. Tang, H.L. Ma: Tool Engineering, Vol. 41 (2007) No. 11, p.89 (In Chinese).

[4] Q.H. Song, X. Ai, Y. Wan and W.X. Tang: Mechanical Strength, Vol. 30 (2008) No. 5, p.718 (In Chinese).