Preparation of Friction Materials by Solution Mixing Based Palygorskite Nanometer/PF Composite Resin and Tribological Behavior of Four Kinds of Woven Friction Materials

Da Bin Zhang; Jian Yu Wei; Can Li Li; Yang Cao

doi:10.4028/www.scientific.net/AMM.275-277.1666

Paper Titles

Cross Coupling Effect in Multi-Element Composites for Transducer Array Application
p.1650

Detection of the Intermediates in Preparation of Ammonium Polyphosphate by Temperature Raising Rate Factor
p.1654

Comparison of the Flame Retardant Properties of Ammonium Polyphosphates with Crystalline Forms II and V
p.1658

Ionic Liquid 1-Butyl-3-Methylimidazolium Chloride/FeCl₃ Pretreatment of Sugarcane Residue for Second Generation Bioethanol Production
p.1662

Preparation of Friction Materials by Solution Mixing Based Palygorskite Nanometer/PF Composite Resin and Tribological Behavior of Four Kinds of Woven Friction Materials
p.1666

Wear Process and Analysis of Lubrication Failure about Sputtering MoS₂ Composite Solid Films Applied to Spacecraft
p.1671

Acoustic Characters Study on the Influence of Micro-Fillings in Underwater Sandwich Composite Structure
p.1678

Effect of Cu(Cr_0.2Al_0.8)₂O₄/TiO₂ Composite Film Electrodes on DSSC Photoelectric Properties
p.1683

Interface Parameters of Composite Materials with an Elliptical Cross-Section Fiber Bundle
p.1688

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vols. 275-277Preparation of Friction Materials by Solution...

Preparation of Friction Materials by Solution Mixing Based Palygorskite Nanometer/PF Composite Resin and Tribological Behavior of Four Kinds of Woven Friction Materials

Abstract:

Palygorskite/tung oil phenolic complex material (MP) was prepared by means of solution mixing. The scattered state of the nano-particles was characterized by transmission electron microscope (TEM). The heat resistance of which MP and SP were prepared by means of in-situ polymerization and boron modified palygorskite nanometer composite resin (BP) and P0.0 without palygorskite nano-particles were contrasted and analyzed by SETARAM TG-DSC92-16, and the four friction materials separately made of MP, SP ,BP and P0.0 were used for tests of friction by the DMS-1. The results show that palygorskite nano-particles with 0.7% in MP have fair dispersibility, and the thermal weight loss of MP compared with P0.0 falls 6%. Its heat resistance closes to SP’s and is with 50°C higher than P0.0’s. So the MP has good tribological behavior.