A New Forming Method of Tapered Wire-Pole with Square Cross-Section

Abstract:

It is difficult to give shapes for tapered wire-pole with square cross-section in conventional plastic working process. A new dieless drawing method for making wire-pole has been developed. Through the dieless drawing theoretical study and experimental analysis of the wire-pole, a new wire-pole dieless drawing process is developed. The methods to ascertain key technique parameter are given out and the drawing velocity model is established. The experimental study shows that the dieless drawing technique is reasonable novel, the equipment is simple and one dieless drawing production procedure can replaces complete forming procedure in the general for tapered wire-pole dieless forming, which completes the deformation heat treatment, enhances the product’s overall performance simultaneously and has the practical value.

• Periodical: Applied Mechanics and Materials (Volumes 373-375)
• Pages: 2004-2007
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.373-375.2004
• Online since: August 2013
• Authors: Hong Yan Xia, Zhan Jun Qi, Di Wu
• Keywords: Dieless Drawing, Drawing Velocity Model, Plastic Working Process, Tapered Wire-Pole, Technique Parameter

References

[1] L. Guifu, C. Li, D. Xuexin: J. Acta Metallurgica Sinica, VOL 35(1) (1999), p.616.

[2] M. Gliga, T. Canta: J．Wire Industry, VOL 6 (1999), p.294.

[3] Y. Kawaguchi, K. Katsube, M. Mujrahashi: J．Wire Journal International, VOL 12 (1991), p.53.

[4] W. Zhongtang, Z. Shaohong, L. Guifu: J．Journal of Materials Processing Technology, VOL 120 (2002), p.90.

[5] X. Hongyan, W. Di: J．Journal of Northeastern University（Natural Science）, VOL30(6) (2009), p.833.