Casting Die Designing for Drive Cover

Ao Bing Wang; Li Ping Zhang; Liu Peng; Li Yong Ni

doi:10.4028/www.scientific.net/AMM.378.346

Paper Titles

Optimization for Amplitude Modulator of THz Wave Based on Polymer Waveguide
p.322

Research on the Failure Judgment of Sprag Clutch Based on Wear Loss
p.329

Based on Lifting Wavelet Voltage Sag Detection Algorithm and Achieve
p.335

The Defect Classification of TFT-LCD Array Photolithography Process via Using Back-Propagation Neural Network
p.340

Casting Die Designing for Drive Cover
p.346

Casting Mold Designing for Aluminum Alloy Car Holders
p.350

Flow Simulations for NASA CRM Wing-Body-Tail with Implicit Hole Cutting Method
p.355

Experimental Study on Cavitation Boundary of Journal Bearing
p.362

Modelling and Design of Closed-Loop Manufacturing Systems
p.367

HomeApplied Mechanics and MaterialsApplied Mechanics and Materials Vol. 378Casting Die Designing for Drive Cover

Casting Die Designing for Drive Cover

Abstract:

The driving covers casting with complex shape belongs to irregular casting. According to the requirements of size and performance of the thin-walled castings, the expanding-type runner of the trapezoid shape section was adopted, conducive to the production of thin-walled castings. The parting surfaces of the die-casting die are the interface of the movable die and fixed die and that of left and right slider. The left and right slider would be reset by spring. Proved by actual production, the mold operated smoothly, without clamping stagnation, and the production of die castings meet delivery requirements.