The Principle and Calibration of the Third Gear Flow-Meter

Abstract:

At present, the domestic development of the gear flow-meter is far behind the developed countries, especially in the micro gear flow-meter. This paper proposes a typical structure named the third gear flow-meter. The structural characteristics and working principle of the third gear flow-meter was introduced in detail, the prototype of the third gear flow-meter was designed and processed, and the calibration tests and pressure experiments of the third gear flow-meter prototype was made at last. We can draw that the three gear flow-meter can be used in hydraulic system pressure range is less than 25Mpa, the flow rate was 0.15~0.2m³/h can meet the high requirements of the stability of measurement, and the measurement accuracy in the whole flow range is 0.2 class. This article provides a reliable experimental data for the design of the micro gear flow-meter.

• Periodical: Applied Mechanics and Materials (Volumes 397-400)
• Pages: 1713-1717
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.397-400.1713
• Online since: September 2013
• Authors: Jun Zhang, Meng Meng Niu, Hong Mei Tang, Xian Hua Li, Cun Ren Tang
• Keywords: Calibration Experiment, Gear Flow-Meter, Pressure

References

[1] Chen Yijian . High two meters high bi-directional elliptical gear flow-meter study [Dissertation]. Zhejiang University. 2008 (In Chinese).

[2] Liu Lianzhu . Who flow calibration measurement system device research [Dissertation]. Northeastern University. 2008 (In Chinese).

[3] Pan Wei. Research on turbine flow-meter calibration based on control system. [Dissertation] Dalian. 2006 (In Chinese).