Equal Strength Continuous Sucker Rod's Optimization Design

Abstract:

In this paper, through the plunger Department of the sucker rod to conduct stress analysis, get the force of the plunger department; then create a mathematical model in the general position, because resistance along the way, dead weight, friction forces and so on, the sucker rod from the bottom up force will show increasing trend, according to equal strength concept, analysis each section forces to calculate the iteration equation; using MATLAB simulation software, the calculated result as control variables to achieve the sucker rod's optimal design.

• Periodical: Applied Mechanics and Materials (Volume 419)
• Pages: 240-243
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.419.240
• Online since: October 2013
• Authors: Jian Dong Ma, Yu Xiang Li, Shu Zhong Lin
• Keywords: Axial Force, Continuous Sucker Rod, Equal Strength, Optimization Design

References

[1] Lu Yi, Equal strength multi-stage sucker rod's parameter optimization, 2001, 18(3).

[2] Wang haibin, Sucker rod's stress analysis and optimization management, 2004, 26(4).

[3] Li Jiankang, The tension member's clamping principle of equal strength, 2008, 44.

[4] Xia Qibiao, Liu Yonghui, Zhou Xinfu, Biesiliangke formula calculate the directional drilling rod's discussion, 2004, 32(9).

[5] Miao Changshan, Huang Yuanlin and Wang Hanxiang, Rod eccentric wear and analysis of three-dimensional mechanical model, 2007, 35(12): 28- 31.