Distinct Element Modeling of the Effect of Joint Persistence on Dynamic Fracturing of Jointed Rock Masses

Abstract:

Rock masses consist of intact rock and discontinuities such as faults, joints and bedding planes. The presence of such discontinuities in rock masses dominates the response of jointed rock masses to static and dynamic loading. These structural weak planes seriously hinder and affect the propagation of stress waves in rock mass. The joints parameters such as persistence, orientation, distribution patterns, spacing and filling material have a significant effect on the response of rock masses against wave propagation. In most studies of blast induced wave propagation in jointed rock mass, it is assumed that joints are continuous. In many situations the rock mass consists of non-continuous joints and rock bridges. Rock bridges and discontinuous joints have a different effect on wave and fracture propagation in a blasting operation. With regard to complexities associated with rock blasting in particular in jointed media, numerical tools are viable alternatives for rock blasting analysis. In this study the DEM methods was employed to investigate the effects of rock bridges on the wave propagation process. A plain strain 2D scenario was assumed and a single blasthole explosion was simulated. Three models with different jointing orientation patterns including jointing pattern parallel to free face, perpendicular to free face and orientated at 45 degree with respect to free face were analyzed numerically to investigate rock mass fracturing while blast wave propagation. The discontinuous joints were considered to be filled with weak materials (open joints) and rock bridges are composed of intact rock. In order to allow material plastic failure, a Mohr-Coulomb material model was used. The analysis results show that the stress concentration at the rock bridge location leads to excessive fracturing. This effect is more visible at the free face where the stress wave reflection occurs. Moreover, the obtained results show that the pattern and orientation of non-continuous joint system has a pronounced effect on rock fragmentation.

• Periodical: Applied Mechanics and Materials (Volume 553)
• Pages: 445-451
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.553.445
• Online since: May 2014
• Authors: Zeinab Aliabadian*, Mansour Sharafisafa
• Keywords: Blast Induced Wave Propagation, Discontinuity, Distinct Element Method, Dynamic Loading, Rock Bridge

References

[1] K. Iwata, T. Sasaki, R. Yoshinaka, Static and dynamic response analysis of rock mass considering joint distribution and itsapplicability, Proc. Of 12th Int. Congr. Of ISRM (2012), 233-236.

DOI: 10.1201/b11646-35

[2] K. Kunii, C. Tanimoto, M. Nakamura, K. Kishiada, Effect of discontinuity to rock deformability, J of JSCE, (1997), 575/III-40, 121-130.

DOI: 10.2208/jscej.1997.575_121

[3] R. Yoshinaka, J. Yoshida, T. Sasaki, K. Asaki, Evaluation of mechanical design parameters of rock discontinuities considering scale effect, J of JSCE (2006), 2/Vol. 62, 457-470.

DOI: 10.2208/jscejc.62.457

[4] S.G. Chen, & J. Zhao, A study of UDEC modeling for blast wave propagation in jointed rock masses, Int J Rock Mech Min Sci (1998), 35(1): 93–9.

DOI: 10.1016/s0148-9062(97)00322-7

[5] S.G. Chen, J.G. Cai, J. Zhao, Y.X. Zhou, Discrete element modelling of an underground explosion in a jointed rock mass. Geotech Geol Eng (1995), 18: 59–78.

[6] R.T. Coates, M. Schoenberg, Finite difference modelling of faults and fractures. Geophysics (1995), 60: 1514–26.

DOI: 10.1190/1.1443884

[7] W.D. Lei, Numerical studies on 2-D compression wave propagation in jointed rock masses , PhD Thesis Singapore 2005: Nanyang Technological University.

[8] R.D. Hart, An introduction to distinct element modelling for rock engineering. In: Hudson JA, editor. Comprehensive Rock Engineering. (1993) Vol. 2. p.245–61.

[9] S.H. Cho, K. Kaneko, Influence of the applied pressure waveform on the dynamic fracture processes in rock. Int J Rock Mech Min Sci (2004) 41: 771–84.

DOI: 10.1016/j.ijrmms.2004.02.006

[10] A. Mortazavi, H. Molladavoodi, A numerical investigation of brittle rock damage model in deep underground openings. Engng Fract Mech (2012)90: 101-120.

DOI: 10.1016/j.engfracmech.2012.04.024

[11] X. Xia, H.B. Li, J.C. Li, B. Liu, C. Yu, A case study on rock damage prediction and control method for underground tunnels subjected to adjacent excavation blasting. Tunnelling and Underground Space Technology 2013; 35: 1–7.

DOI: 10.1016/j.tust.2012.11.010

[12] Haque, Asadul, Shear behavior of soft rock joint under constant normal stiffness, PhD Thesis, Department of Civil and Mining Engineering 1999, University of Wollongong, Australia.

[13] Q. Liu, P. Tidman, Estimation of the dynamic pressure around a fully loaded blasthole. Technical report, MRL 95-014 (1995), CANMET/MRL.

[14] E. Fathi Salmi, Numerical modeling of delay timing effect on rock fragmentation between blastholes, MSc thesis, Amirkabir University of Technology, (2009), Tehran, Iran.