Temperature Zoning of Libya Desert for Asphalt Mix Design

Abstract:

The current asphalt binder specifications in Libya are based on the Penetration Grade: penetration test is performed at 25°C. Penetration is an empirical measure of the consistency that is used as an empirical indicator of the rutting and fatigue susceptibility of asphalt binder, and is not related to pavement performance. The new mix design methodology developed under the Strategic Highway Research Program (SHRP), called the SUPERPAVE is a performance-based approach. The first step in the implementation of SUPERPAVE methodology is to establish high and low pavement temperatures for a location. The temperatures define the required Performance Grade (PG) of asphalt binder. This paper documents the initial ground work towards implementation of SUPERPAVE mix design for establishing high and low geographical temperature zones. The temperature zoning of Libya was carried out by using temperature data obtained from 8 weather stations. The SHRP and LTPP prediction models were utilized for predicting pavement temperatures. A significant difference was observed between the predicted pavement temperatures from both the models. The SHRP model gives higher, high temperature PG grade providing additional protection against rutting. Since rutting is the most common distress on flexible pavements in Libya , the SHRP models at 50% level of reliability is recommended. The PG of roads that located in Libyan desert are classified to three zones (PG70-10, PG76-10 and PG82-10.PG 76-10 binder seems to be the most common grade that encompasses more than 70% area of Libya desert .However, currently none of the two local refineries produce the bitumen under penetration grade 60-70,that grade equivalent to PG 82-10 binder, thus it should be a concern for highway or the project location. The polymer modified asphalt binder are not produced by Libya refineries.

• Periodical: Applied Mechanics and Materials (Volumes 638-640)
• Pages: 1414-1426
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.638-640.1414
• Online since: September 2014
• Authors: Hassan Awadat Salem*, Djordje Uzelac, Bojan Matic
• Keywords: LTPP, Penetration Grade, Performance Grade, SHRP, Superpave, Temperature Zoning

References

[1] SUPERPAVETM Asphalt Mixture Design & Analysis, National Asphalt Training Center, Demonstration Project 101, Federal Highway Administration, Office of Technology Applications, Washington DC and Asphalt Institute, Lexington, KY. September (1994).

[2] Welborn, J. Y. and W. J. Halstead (1974). Testing of Asphalts and Asphalt Mixtures, Proceeding Advanced Asphalt Pavement Technologists (AAPT), Vol. 43A.

[3] Diefenderfer, B. K., Al-Qadi, I. L., Reubush, S. D., and Freeman, (2002). T. E., Development and Validation of a Model to Predict Pavement Temperature Profile, Presented at Transportation Research Board 82nd Annual Meeting, Washington, DC.

DOI: 10.1061/(asce)0733-947x(2006)132:2(162)

[4] Mohseni, A. (1998). LTPP Seasonal Asphalt Concrete (AC) Pavement Temperature Models, Report No. FHWA-RD-97-103, Federal Highway Administration, US Department of Transportation.

[5] Huber, G.A., (1994). Weather Database for the SUPERPAVE Mix Design System, SHRP-A-648A.

[6] Aurangzeb, Q., (2008). School of Civil and Environmental Engineering (NIT), National University of Science and Technology (NUST), Master Thesis.

[7] Libya Meteorological Department (2005). Climatic normals of Pakistan (1971-2000)., Climatic Data Processing Centre.

[8] Website: http: /en. wikipedia. org/wiki/Weather Underground_(weather_service).