Impact Toughness Influence on the Bending Properties of Rock Bolt

Abstract:

—Abstract: The use of high-strength rock bolt in the underground often occured brittle fracture in the threaded section, this is closely related to bolt material impact toughness. Tested the impact absorbed energy of four manufacturers of the yield strength of 500MPa rock bolt and the impact absorbed energy value ranging from 19J to 165J. Tested bending test of the bolt rod and threaded section that has a different impact absorbed energy, the results showed that: the impact toughness affects the cold bending of the rock bolt thread segment, when the impact absorbed energy value is less than 30J rock bolt thread segment cold bending poor; impact toughness has no obvious affect on the cold bending of rod.

• Periodical: Applied Mechanics and Materials (Volume 664)
• Pages: 94-97
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.664.94
• Online since: October 2014
• Authors: Zhong Wei Li*
• Keywords: Bending Properties, Brittle Fracture, High-Strength Rock Bolt, Impact Toughness

References

[1] Kang Hongpu. Development and application of pre-stress anchored bolt supporting technology in coal mine[J]. Coal Mining Technology, 2011(100): 25-30.

[2] Kang Hongpu. Deep coal roadway rock bolting theory and technology research progress[J]. Coal Mining Support, 2007(2): 1-8.

[3] Kang Hongpu, Wang Jinhua. Rock bolting theory and complete technology for coal roadways [M]. Beijing: Coal Industry Press, (2007).

[4] Ju wenjun. Analysis of Supporting Principles of Anchor-bolt in Roadway with Burst Danger [J]. Coal Mining Technology, 2009(3): 59-61.

[5] Ju wenjun. Energy Checking Design Method of Roadway with Rock-burst Danger[J]. Coal Mining Technology, 2011(3): 81-83.

[6] Lin Jian, Kang Hongppu. Research status-quo and tendency of thread-steel resin anchored bolt[J]. Coal Mining Technology, 2009(4): 1-4.

[7] Liu Mingfang, Liu Shengxin. Mechanical properties of metallic materials handbook[M]. Beijing: Machinery Industry Press, (2011).

[8] Xu Zhiming, Liu Gang. Some basic knowledge of material toughness[J]. Use and maintenance of farm machinery, 2010(2): 49-51.

[9] Chinese National Standards. GB/T 232-1999, Metallic materials-Bend test[S]. State Quality and Technical Supervision, (2000).

[10] Chinese National Standards. GB 1499. 2-2007, Steel for the reinforcement of concrete-Part2: Hot rolled ribbed bars[S]. China National Standardization Management Committee, (2008).

[11] Chinese National Standards. GB 2975-82, Rules for sampling in mechanical and technological testing of steel products[S]. National Standards Administration, (1982).