Tribological Characteristics of Tetrahedral (ta-C) DLC Coating in the Presence of Commercial Lubricating Oil

Abstract:

Currently, the application of diamond-like carbon (DLC) coatings for automotive components is becoming a favorable strategy to cope with the new challenges faced by the automotive industry. DLC coatings can effectively lower the coefficient of friction (CoF) and wear rate of engine components, consequently improving the fuel efficiency and durability of these components. Commercially available fully formulated lubricating oils enhance the lubrication of ferrous materials. Therefore, the interaction between nonferrous coatings (e.g., DLC) and commercial lubricating oil must be investigated. A ball-on-plate tribotester was used to run the experiments using stainless steel plates coated with tetrahedral DLC (ta-C) sliding against a 440C stainless steel ball. Wear track was investigated by scanning electron microscopy and atomic force microscopy. Energy dispersive spectroscopy was used to analyze the tribofilms inside the wear track. Raman analysis was performed to investigate the structural change of the coatings. At high temperatures, the CoF decreases but the wear rate increases in the ta-C DLC-coated plates. CoF and wear rate (coated layer and counter surface) are mostly influenced by coating graphitization.

• Periodical: Applied Mechanics and Materials (Volume 679)
• Pages: 25-29
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.679.25
• Online since: October 2014
• Authors: K.A.H. Al Mahmud, M.A. Kalam, M.F.M. Sabri, H.H. Masjuki, M.M. Rashed
• Keywords: Coefficient of Friction, Graphitization, Wear Rate

References

[1] K. Baba, R. Hatada, Surface and Coatings Technology, 169 (2003) 287-290.

[2] Z.Q. Fu, C.B. Wang, W. Wang, Z.J. Peng, X. Yu, S.S. Lin, M.J. Dai, Key Engineering Materials, 434 (2010) 477-480.

[3] C.W. Zou, H.J. Wang, L. Feng, S.W. Xue, Applied Surface Science, 286 (2013) 137-141.

[4] S. Equey, S. Roos, U. Mueller, R. Hauert, N.D. Spencer, R. Crockett, Wear, 264 (2008) 316-321.

DOI: 10.1016/j.wear.2007.03.012

[5] B. Podgornik, S. Jacobson, S. Hogmark, Tribology International, 36 (2003) 843-849.

[6] K.A.H. Al Mahmud, M. Varman, M.A. Kalam, H.H. Masjuki, H.M. Mobarak, N.W.M. Zulkifli, Surface and Coatings Technology, 245 (2014) 133-147.

DOI: 10.1016/j.surfcoat.2014.02.052

[7] H. Ronkainen, S. Varjus, J. Koskinen, K. Holmberg, Wear, 249 (2001) 260-266.

DOI: 10.1016/s0043-1648(01)00558-0

[8] A.C. Ferrari, J. Robertson, Philosophical Transactions of the Royal Society of London. Series A: Mathematical, Physical and Engineering Sciences, 362 (2004) 2477-2512.

DOI: 10.1098/rsta.2004.1452