Synthesis and Characterization of Low-Cost Porous Carbon from Palm Oil Shell via K₂CO₃ Chemical Activation Process

Abstract:

The abundant fraction of agricultural waste materials in the environment that poses disposal challenge could be converted into useful value added products such as activated carbon. Palm oil shell based carbon was prepared by two step process using K₂CO₃ as the chemical activant. The Langmuir surface area, BET surface area and pore volume were 817 m²/g, 707m²/g and 0.31cm³/g. From the FTIR analysis, carbonyls, alkenes and hydroxyls were identified. The SEM image shows gradual formation of pores due to elimination of volatiles and contaminants. Carbonization at 800°C for 2 hours and activation at same temperature for 1h has the highest yield of 23.27%. The proximate and ultimate analysis shows high percentage of carbon and low percentage of ash which is an indication of a good material for production of porous carbon. The activated carbon produced showed basic properties suitable for removal of organic contaminants in aqueous solutions. However, the aim of this study is to produce a green and porous carbon with controlled pores and surface properties for organic contaminants removal from water and wastewater.

• Periodical: Applied Mechanics and Materials (Volume 735)
• Pages: 36-40
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.735.36
• Online since: February 2015
• Authors: Noor Shawal Nasri, Hatijah Basri, Abdurrahman Garba*, Usman Dadum Hamza, Jibril Mohammed, Ahmed M. Murtala
• Keywords: Adsorbent, Chemical Activation, Palm Oil Shell, Potassium Carbonate

References

[1] G. Z. Kyzas and M. Kostoglou, Green Adsorbents for Wastewaters: A Critical Review,, Materials, vol. 7, pp.333-364, (2014).

DOI: 10.3390/ma7010333

[2] N. S. Nasri, et al., Synthesis and Characterization of Green Porous Carbons with Large Surface Area by Two Step Chemical Activation with KOH,, Jurnal Teknologi, vol. 67, (2014).

DOI: 10.11113/jt.v67.2787

[3] M. Rafatullah, et al., Oil Palm Biomass as a Precursor of Activated Carbons: A Review,, Critical Reviews in Environmental Science and Technology, vol. 43, pp.1117-1161, 2013/04/01 (2012).

DOI: 10.1080/10934529.2011.627039

[4] M. Jibril, et al., Removal of Colour from Waste Water Using Coconut Shell Activated Carbon (CSAC) and Commercial Activated Carbon (CAC),, Jurnal Teknologi, vol. 60, p.15–19, (2013).

DOI: 10.11113/jt.v60.1435

[5] I. Tan, et al., Equilibrium and kinetic studies on basic dye adsorption by oil palm fibre activated carbon,, Chemical Engineering Journal, vol. 127, pp.111-119, (2007).

DOI: 10.1016/j.cej.2006.09.010

[6] R.-L. Tseng, Mesopore control of high surface area NaOH-activated carbon,, Journal of colloid and interface science, vol. 303, pp.494-502, (2006).

DOI: 10.1016/j.jcis.2006.08.024

[7] L. wang, et al., A novel route for preparation of high-performance porous carbons from hydrochars by KOH activation,, Colloids and Surfaces A: Physicochemical and Engineering Aspects, (2014).

DOI: 10.1016/j.colsurfa.2014.01.013

[8] D. Adinata, et al., Preparation and characterization of activated carbon from palm shell by chemical activation with K2CO3,, Bioresour Technol, vol. 98, pp.145-9, Jan (2007).

DOI: 10.1016/j.biortech.2005.11.006

[9] H. Demiral, et al., Production of activated carbon from olive bagasse by physical activation,, Chemical Engineering Research and Design, vol. 89, pp.206-213, (2011).

DOI: 10.1016/j.cherd.2010.05.005

[10] J. i. Hayashi, et al., Preparing activated carbon from various nutshells by chemical activation with K₂ CO₃,, Carbon, vol. 40, pp.2381-2386, (2002).

DOI: 10.1016/s0008-6223(02)00118-5

[11] K. Y. Foo and B. H. Hameed, Preparation, characterization and evaluation of adsorptive properties of orange peel based activated carbon via microwave induced K2CO3 activation,, Bioresour Technol, vol. 104, pp.679-86, Jan (2012).

DOI: 10.1016/j.biortech.2011.10.005

[12] K. Foo and B. Hameed, A cost effective method for regeneration of durian shell and jackfruit peel activated carbons by microwave irradiation,, Chemical Engineering Journal, vol. 193, pp.404-409, (2012).

DOI: 10.1016/j.cej.2012.04.055

[13] A. Arami-Niya, et al., Using granular activated carbon prepared from oil palm shell by ZnCl2 and physical activation for methane adsorption,, Journal of Analytical and Applied Pyrolysis, vol. 89, pp.197-203, (2010).

DOI: 10.1016/j.jaap.2010.08.006

[14] W. M. A. W. Daud and W. S. W. Ali, Comparison on pore development of activated carbon produced from palm shell and coconut shell,, Bioresource technology, vol. 93, pp.63-69, (2004).

DOI: 10.1016/j.biortech.2003.09.015

[15] J. Guo, et al., Adsorption of NH₃ onto activated carbon prepared from palm shells impregnated with H₂ SO₄,, Journal of colloid and interface science, vol. 281, pp.285-290, (2005).

DOI: 10.1016/j.jcis.2004.08.101

[16] A. L. Cazetta, et al., NaOH-activated carbon of high surface area produced from coconut shell: Kinetics and equilibrium studies from the methylene blue adsorption,, Chemical Engineering Journal, vol. 174, pp.117-125, (2011).

DOI: 10.1016/j.cej.2011.08.058