Minimizing of Rejection in Cylinder Head Machining Using the Anova Method

Abstract:

The main rejections in the machining sections are exhaust valve port leak, injector bore blow hole, induction passage punchered, inlet valve port leak, top face unwash, valve guide hole blow hole, top face leak, joint face unwash, induction face unwash, rear face unwash, valve port unwash, water mixing with oil., water passage blocked, emf leak, injector bore leak, inlet valve port blocked, water way leak, oil way leak and defective jig location pad. This paper describes the method by which the rejections while maching the cylinder head, is minimized.

• Periodical: Applied Mechanics and Materials (Volumes 766-767)
• Pages: 935-940
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.766-767.935
• Online since: June 2015
• Authors: C. Jothi Shanmugam*
• Keywords: ANOVA, Cylinder Head, Machining, Rejection

References

[1] Reducing rejection rate of castings using Simulation Model-Binu Bose V, K N Anilkumar International Journal of Innovative Research in Science, Engineering and Technology, Volume 2, Special Issue 1, December (2013).

[2] Casting cost estimation in an integrated product and process design environment-R. G. Chougule&B. Ravi *-Revised paper submitted for publication in IJCIM, Dec (2005).

[3] Optimization of green sand casting process parameter by taguchi method: A review-S.S. Jamkar1, M.J. Deshmukh2, N.A. Vidhate3, International Journal of Mechanical EngineeringISSN : 2277-7059 Volume 4 Issue 1 (January 2014).

[4] Optimization in green sand casting process forefficient, economical and quality casting*RaghwendraBanchhor, S.K. Ganguly-Banchhor et al., International Journal of Advanced Engineering Technology E-ISSN 0976-3945.

[5] Development of casting techniques for polyethersulfone ultra filtration membranes and their effects on flux and rejection V. S. Sapkal1, Prafulla G. Bansod2, R.S. Sapkal3-International Journal of Chemical Sciences and Applications ISSN 0976-2590. Vol 2, Issue 2, June-2011, pp.156-161.

[6] Process Factor Optimization to Enhance Productivity of Green Sand Casting Process by Using Taguchi Methodology Rajesh Rajkolhe1, J. G. Khan2-International Journal of Research in Advent Technology, Vol. 2, No. 6, June 2014 E-ISSN: 2321-9637.

[7] P. N. Rao, 1998, Manufacturing Technology-Foundry, Forming and Welding, Tata McGraw-Hill Publications, New-Delhi.

[8] Achamyeleh A. Kassie and Samuel B. Assfaw Minimization of Casting Defects, IOSR Journal of Engineering (IOSRJEN) Vol. 3, Issue 5 (May. 2013).

[6] Tapan Roy Analysis of Casting Defects in Foundry by Computerised Simulations (CAE) - A New Approach along with Some Industrial Case Studies, Transaction of 61st Indian foundry congress (2013).