Aspects of Searching some Possibilities to Diminish the Processing Errors at Stamping Process

Abstract:

Processing errors in the process of stamping, represent some of the most important aspect that requires attention when you want to process parts with a simple configuration. Reducing errors increase the quality of stamped parts, therefore the processing industry of blanks from metal sheets attaches great importance to them. Given the international quality standards it is required to study in detail the problem of eliminating these errors. As a result the results of researches on the establishment of a special portable device to eliminate the clearance between the sheet metal and the guidance rulers of the material in die in order to reduce the deformations of the sheet metal trough successive actions dies. Are presented the proposed constructive solution, its advantages and experimental measurements at stamping with the use of the proposed solution.

• Periodical: Applied Mechanics and Materials (Volumes 809-810)
• Pages: 295-300
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.809-810.295
• Online since: November 2015
• Authors: Sergiu Constantin Olaru*, Gheorghe Nagit, Marius Ionuţ Ripanu, Vasile Manole
• Keywords: Blank's Clearance, Control Device, Deformations, FEA Analysis, Guiding Rulers, Special Portable Device, Tensions

References

[1] **, Stamping, available at https: /en. wikipedia. org/wiki/Stamping_(metalworking) , accessed: 9. 01. (2015).

[2] M.R. Leenders, L.A. Mauffette-Launder, J. Erskine, Writing Cases, Ivey Publishing, 4th edition, 2013, available at, http: /www. slideshare. net/hrsivaraman/6765573-casestudies, accessed: 9. 01. (2015).

[3] V. Braha, et al., Cold pressing technology, Publisher CERMI, Iași, (2003).

[4] Schuler GmbH, Metal Forming Handbook available at, http: /link. springer. com/book/10. 1007/ 978-3-642-58857-0 , accessed: 9. 01. (2015).