Investigation of BTEX Adsorption on Carbon Nanotubes Cartridges from Air Samples

Abstract:

The volatile organic compounds (VOCs) contribute to serious air pollution problems in Viet Nam. Many studies have investigated in air quality monitoring and treatment, in order to determine the average concentrations of Benzene, Toluene, Ethylbenzene and Xylene (BTEX). Carbon nanotubes (CNTs) have been widely used as adsorbent in environmental treatment, especially for VOCs. This paper aims to determine the adsorption capacity of multiwalled carbon nanotubes for removal of BTEX from air samples. In preliminary study, the effects of various parameters during adsorption experiments were monitored such as flow rate, temperature and BTEX concentrations in air samples. The equipment for BTEX removal was developed by our research team consisting of filter columns, air sample bags, adsorption cartridge. The air samples containing BTEX were conducted directly through a cartridge packed with adsorbent. The adsorption experiments were carried out under various operating conditions such as temperature (30 - 40°C), gas concentration (0,57 - 4,77 mg/L) and the gas flow rate (10 - 90 mL/min). In addition, isotherm studies of CNTs for BTEX removal were achieved by using Langmuir and Freundlich models. The results showed that the experimental parameters were optimized at a flow rate of 30 mL/min and an ambient temperature at 30°C. The adsorption capacity of CNTs increased proportionally with BTEX concentrations. The specific affinity of CNTs for BTEX from air samples was in order of X > E > T > B. The experimental isotherm data were well-fit with the Langmuir model for Benzene and Xylene removal, and the Freundlich model for Toluene and Ethylbenzene adsorption. The CNTs presented highly potential application for BTEX adsorption thanks to their microporous structure and high surface area.

• Periodical: Applied Mechanics and Materials (Volume 889)
• Pages: 216-222
• DOI: https://doi.org/10.4028/www.scientific.net/AMM.889.216
• Online since: March 2019
• Authors: Huu Quynh Anh Le*, Dinh Tuan Phan
• Keywords: Adsorption Capacity, Air Pollution, BTEX, Carbon Nanotubes, VOCS

References

[1] X. Peng, Y. Li, Z. Luan, Adsorption of 1,2-dichlorobenzene from water to carbon nanotubes, Chem. Phys. Lett. 376 (2003) 154-158.

[2] S. Gotovac, C.M. Yang, Y. Hattori, K. Takahashi, H. Kanoh, K. Kaneko, Adsorption of polyaromatic hydrocarbons on single wall carbon nanotubes of different functionalities and diameters. J. Colloid Interface Sci. 314 (2007) 18-24.

DOI: 10.1016/j.jcis.2007.04.080

[3] R.Q. Long and R.T. Yang, Carbon nanotubes as superior sorbent for dioxin removal, J. Am. Chem. Soc. 123 (2001) (2058).

DOI: 10.1021/ja003830l

[4] Irving Langmuir, The adsorption of gases on plane surfaces of glass, mica and platinum. J. Am. Chem. Soc. 40 (9) (1918) 1361-1403.

DOI: 10.1021/ja02242a004

[5] H. Freundlich, Adsorption in solution, Physical Chemistry 57 (1906) 384-410.

[6] M. Jahangiri and S. J. Shahtaheri, The adsorption of Benzene, Toluene and Xylenes (BTX) on the carbon nanostructures: the study of different parameters, Fresenius Environmental Bulletin 20 (4a) (2011).

[7] D. Das and V.Gaur, Removal of volatile organic compound by activated carbon fiber, Carbon 42 (2004) 2949-2962.

DOI: 10.1016/j.carbon.2004.07.008

[8] H. Sone and B. Fugetsu, Affinity-based elimination of aromatic VOCs by highly crystalline multiwalled carbon nanotubes Talanta 74 (2008) 1265-1270.

DOI: 10.1016/j.talanta.2007.08.041

[9] A.M. Daifullah, B.S. Girgis, Impact of surface characteristics of activated carbon on adsorption of BTEX, Colloids and Surfaces Journal A: Physicochemical and Engineering Aspects 214 (1−3) (2003) 181−193.

DOI: 10.1016/s0927-7757(02)00392-8

[10] X. Ren, C. Chen, M. Nagatsu -Carbon nanotubes as adsorbents in environmental pollution management: A review, Chemical Engineering Journal 170 (2-3) (2011) 395-410.

DOI: 10.1016/j.cej.2010.08.045