Influence of Mould Release Agent on Surface Properties of Concrete with Special Matrix

Radka Pernicová; Michaela Kostelecká

doi:10.4028/www.scientific.net/AMR.1025-1026.637

Paper Titles

Strength of Bonded Joints of Linear Low – Density Polyethylene after Radiation Cross – Linking
p.615

Three-Dimensional Periodic Hematite Photocatalysts Fabricating by Direct Writing Method
p.621

Electrical Discharge Grinding (EDG) of Polycrystalline Diamond - Effect of Machining Polarity
p.628

Study of Degradation of Fiber - Cement Plates with Different Types of Non - Metalic Fibers
p.633

Influence of Mould Release Agent on Surface Properties of Concrete with Special Matrix
p.637

Analysis of Formation and Testing of Efflorescence on Concrete Elements
p.641

Preparation of Iron Catalysts Generated from Fe-Coagulated Sludge Produced by Ferric Chloride Coagulation of Wastewater
p.645

Effect of Liquefying Agents Mixed with Lower Alcohols and Catalyst on the Microwave Driven Liquefaction of Wood
p.651

Polarization Behavior of Steel Corrosion in Laterite, Yellow Soil and Kaolin
p.656

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 1025-1026Influence of Mould Release Agent on Surface...

Influence of Mould Release Agent on Surface Properties of Concrete with Special Matrix

Abstract:

Influence of mould release agent for surface properties of concrete with special matrix are presented in this paper. Porosity, roughness and sorption capacity was tested depending on the selected separators. These properties are very important for architectural concrete or further non-treated concrete mainly due to efflorescence. From the results obtained follows that the different kind of separators as well as type of cements have impact on the concrete surface properties.