Research of Rust Layer Stabilization on Bare Steel

Xian Qiu Huang; Peng Cheng; Feng Jun Lang; Tao Pang; Ying Ma; Jian Rong Liu

doi:10.4028/www.scientific.net/AMR.1120-1121.711

Paper Titles

Research of Microstructure and Hardness of Co55 and W Coating Made by Laser Cladding
p.694

Experimental Study of Nano-Al₂O₃ Particles Reinforced Fe-Based Composite Coating Made by Laser Cladding
p.698

The Effect of Graphite Content on the Wear Behavior of Ni/WC/G Composite Coating
p.702

Corrosion of 50%(Ni-22%Cr-10%Al-1%Y)-50%(ZrO₂-8%Y₂O₃) Coatings in Na₂SO₄ and 75%NaCl-25%Na₂SO₄ Salts
p.707

Research of Rust Layer Stabilization on Bare Steel
p.711

Study on Microstructure of the Matrix/Dense Inner Layer Interface in Micro-Arc Oxidizing on Magnesium Alloys
p.715

Influence of Oxidation Temperature on the High-Temperature Oxide Film Forming Behavior of T22 Heat-Exchange Tubes
p.723

Influence of Passivation Coatings Synthesized by Atomic Layer Deposition on Li-Ion Batteries Cathode Cycle Life
p.730

A Effects of Nano-Particles Additives on Wear Performance of Micro-Arc Oxidation Coating Prepared on 2A12 Aluminum Alloy
p.735

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 1120-1121Research of Rust Layer Stabilization on Bare Steel

Research of Rust Layer Stabilization on Bare Steel

Abstract:

The performance of bare steel’s rust stabilization was studied using cycle immersion corrosion test and X-ray diffraction. The results showed that after specimens were corroded in 3% NaCl solution, rust bubble of stabilized specimen was smaller than rust bubble of unstabilized specimen, corrosion rate of stabilized specimen was lower than corrosion rate of unstabilized specimen, and rust layers of stabilized specimen and unstabilized specimen were mainly composed of γ-FeOOH and Fe₃O₄.