Precision Grinding of SUS304 Using Metal Bonded CBN Wheel

Abstract:

Article Preview

The fundamental experiment of the grinding of the stainless steel using the metal bonded CBN wheel which was excellent in wear resistance was conducted. The most appropriate grinding conditions were obtained by clarifying wear process of grinding wheel and finished ground surface quality. When grinding was carried out up to stock removal 7000mm3/mm, radial wear of grinding wheel %R is 3μm and surface roughness Rz was 0.5μm or less. The grinding ratio Gr becomes about 3000, and long life grinding with little change of surface roughness was possible.

Info:

Periodical:

Advanced Materials Research (Volumes 24-25)

Edited by:

Hang Gao, Zhuji Jin and Yannian Rui

Pages:

261-264

Citation:

Y. Hasuda et al., "Precision Grinding of SUS304 Using Metal Bonded CBN Wheel", Advanced Materials Research, Vols. 24-25, pp. 261-264, 2007

Online since:

September 2007

Export:

Price:

$38.00

[1] H. Tanaka, N. Kumagaya: Journal of the Japan Society for precision Engineering, 58, 4, 601-603 (1992).

[2] T. Matsuo, Y. Ohbuti, Y. Fukui & H. Shibata :Proc. of S.M.E., The Third Int. Grinding Conf, Oct. 4-6, (1989) 1.

[3] H. Notoya, S. Yoneya, Y. Takatsuji: Journal of the Japan Institute of Metals, 52, 2, 217-222 (1988).

[4] Y. Hasuda & K. Kishi:Proc. of International Conference on Precision Surface Finishing and Burr Technology,110-115, (1994)130.

[5] T. Matsuo: Journal of the Japan Society for precision Engineering, 58, 4, 571-612 (1992).

[6] M. Inoue, Y. Kamanaka: Proc. of Spring Conf. of the Japan Society for precision Engineering, 2, 681-682 (1995).

[7] K. Yokoyama, S. Hosotani: Proc. of the Japan Society for Abrasive technology, 186-187(1996).

Fetching data from Crossref.
This may take some time to load.