Relevant Cubic Grain Plank Plastic Strain Ratio (R) the Theory Research and Experiment

Abstract:

This paper shows that different materials have different quadratic functions, tensor function theory can make the function of history to represent the plastic strain, which can be a sheet metal pressing does uniaxial tensile test show that the plane of sheet metal, sheet metal specimen axis and the angle between the rolling direction changes, to the metal plastic strain ratio (R) along with the changes. To explain this phenomenon, the introduction of a quadratic yield function to describe the experimental results of some of the metal sheet. This paper shows that different materials have different quadratic functions, tensor function theory can make the function of history to represent the plastic strain, which can be a sheet metal pressing does not depend on the value of history.

• Periodical: Advanced Materials Research (Volumes 243-249)
• Pages: 5999-6002
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.243-249.5999
• Online since: May 2011
• Authors: Wen Xia Yue, Lang Wu, Li Min Cheng
• Keywords: Rolling Direction, Rotation Tensor, R-Value, Yield Function

References

[1] Whiteley, R. L. The inportance of directionality in deep drawing sheet steel. Trans. ASME 1960,52,154

[2] Bramley, A. N. and Mellor, P. B. Plastic flow in stabilized sheet steel. Int. J. Mech. Sci. 1966, 8, 101

[3] Bramley, A. N. and Mellor, P. B. Plastic anisotropy of titanium and zinc sheet Ⅰ-a macroscopic approach. Int. J. Mech. Sci. 1968, 10, 211

[4] Mellor, P. B. The role of plastic anisotropy in sheet matal forming. Annals C.I.R.P. 1970, 18, 133

[5] Rees, D. W. A. Tensile flow and instability in galvanised, rolled steel sheet. J. Strain Anal. 1955, 30, 305

[6] Rees, D. W. A. and Power, R. K. The influence of orientation on the forming limits. J. Strain Anal, 1977, 32, 61

[7] Rees, D. W. A. A tensor function for the R-value of sheet metal . J. Strain Anal, 1997, 21, 579