Tensile Test of the Fireproof Lining of Tunnel

Rong Yao; Dong Ling Peng; Hong Yuan Huang

doi:10.4028/www.scientific.net/AMR.255-260.170

Paper Titles

Analysis on Bearing Capacity of Solid Multibarrel Tube-Confined Concrete Short Columns (CHS Inner and SHS Outer) under Axial Compressive Load
p.151

Study on Construction Control of Project Manager
p.157

Analysis of Primary Aluminum Composite Panel Gypsum Board Construction Method Paste
p.161

The Quasi-Static Analysis for Two-Dimensional Thin Plates
p.166

Tensile Test of the Fireproof Lining of Tunnel
p.170

Discussion on the Influencing Factors of Deflection-Span Ratio at Failure in Prestressed Concrete Hollow Slab
p.174

Study on Efficiency Factor of Bearing Capacity of Multi-Element Composite Foundation of Concrete Column and Lime Column
p.178

Damage Detection Analysis of Reinforced Concrete Simple Beams Based on Three Dimensional Curvature Mode
p.183

Damage Detection through Changes in Frequency Base on Reinforced Concrete Beam
p.188

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 255-260Tensile Test of the Fireproof Lining of Tunnel

Tensile Test of the Fireproof Lining of Tunnel

Abstract:

The tensile fireproof lining of tunnel test has been done in orthogonal method with a custom-made fast fluctuation thermostat type resistance furnace which the maximum temperature may arrive 1200 °C , the heater was put for heating by choosing the RABT curve, the test result was analyzed, the ratio of tensile strength loss is changed with the meter of the polypropylene textile fiber, the silica flour and the carbon fiber, there is a optimality proportion when the ratio of tensile strength loss is low.