Limit Analysis of Lateral Extrusion of Gear-Like Components with Radial Tooth Profile

H. Haghighat; M. Bajelan

doi:10.4028/www.scientific.net/AMR.264-265.172

Paper Titles

An Evaluation on Processing of Metal Matrix Composites (Al₂O₃/AC8A) by Low-Pressure Infiltration
p.149

Dynamic Model of Compaction Process of Metallic Powders
p.155

Some Aspects of Deposition Parameters of RF Sputtered Ferromagnetic Film Germane to the Study of Magnetoresistive Sensing Devices
p.160

An Elasto-Plastic Finite Element Analysis of the Radial Compression of Aluminium Tube between Rigid Plates
p.166

Limit Analysis of Lateral Extrusion of Gear-Like Components with Radial Tooth Profile
p.172

Axial Crushing of Grooved Thin-Walled Tubes Using Experiments and Finite Element Simulation
p.178

Microstructure and Mechanical Properties of Twist Extruded Pure Aluminum Processed by Post-Rolling
p.183

Investigations about the Single Point Incremental Forming of Anisotropic Titanium Alloy Sheets
p.188

A 3-D Forming Prediction Method of Increase of Sheet Thickness during Drawing Process
p.194

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 264-265Limit Analysis of Lateral Extrusion of Gear-Like...

Limit Analysis of Lateral Extrusion of Gear-Like Components with Radial Tooth Profile

Abstract:

Lateral extrusion of gear- like components with radial tooth profile, has been studied in this paper. To analyze the process, the two types of theoretical approaches, i.e. the upper bound technique and the slab method of analysis have been applied and extrusion load values have been estimated. The theoretical results of load values estimated from the above approaches have been compared with theoretical and experimental results that given by a reference. Good agreement has been found among the predicted load values and those obtained from the experimental results.