The Application of PLC in Hydraulic Metal Band-Sawing Machine Improves Control Circuit

Yu Jian Xie

doi:10.4028/www.scientific.net/AMR.308-310.2250

Paper Titles

Analysis of the Drive of AT Based on the Lever Method
p.2230

Outer Mesh and "Two Teeth Difference" Planetary Gear Transmission Parameter Optimization Design
p.2237

Open CNC System for Winding Machines
p.2243

Research on Fuzzy Control Rule of Anti-Vehicle Rear-End Collision by Matlab and Simulink
p.2247

The Application of PLC in Hydraulic Metal Band-Sawing Machine Improves Control Circuit
p.2250

An Electrical Parking Brake System Design and Analysis
p.2254

The Study of Holonic Control Strategy in Modern Automobile
p.2258

Teaching and Playback of Motion Trajectory Based on Parallel Manipulator
p.2262

Development of Active Suspension System for a Pot Hole Using PID Controller
p.2266

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 308-310The Application of PLC in Hydraulic Metal...

The Application of PLC in Hydraulic Metal Band-Sawing Machine Improves Control Circuit

Abstract:

In order to solve the problem which causes high failure rate and low production efficient in the relay-contactor control system of hydraulic metal band-sawing machine, according to the technological requirement in the sawing process, the article uses PLC as controller to control hydraulic equipment automatically. The results showed that: the control circuit not only satisfies the technological requirement, but also makes sawing more stable and high efficiency.